Toyota Tacoma (2015-2018) Service Manual: Multiplex Communication
- Lin Communication System
- Precaution
- Parts Location
- System Description
- System Diagram
- How To Proceed With Troubleshooting
- Terminals Of Ecu
- Data List / Active Test
- Diagnosis System
- Dtc Check / Clear
- Communication Malfunction between ECUs Connected by LIN (B2785)
- No Response from Steering Lock ECU (B2786)
- Diagnostic Trouble Code Chart
- Sliding Roof ECU Communication Stop (B1273)
- Driver Side Door ECU Communication Stop (B2321)
- LIN Communication Bus Malfunction (B2325)
- P/W Master Switch Communication Stop (B1206)
- Lost Communication with Power Source Control (B278C)
- Front Passenger Side Door ECU Communication Stop (B2322)
Network Gateway Ecu
Components
COMPONENTS
ILLUSTRATION
Installation
INSTALLATION
PROCEDURE
1. INSTALL NETWORK GATEWAY ECU
(a) Install the network gateway ECU with the bolt.
Torque:
3.0 N·m {31 kgf·cm, 2 ...
Other materials:
Air Fuel Ratio Sensor
Components
COMPONENTS
ILLUSTRATION
Removal
REMOVAL
PROCEDURE
1. REMOVE AIR FUEL RATIO SENSOR (for Bank 1 Sensor 1)
(a) Disconnect the air fuel ratio sensor connector.
(b) Disengage the clamp to separate the air fuel ratio sensor wire ...
Installation
INSTALLATION
CAUTION / NOTICE / HINT
HINT:
Use the same procedure for both the RH and LH sides.
The procedure described below is for the LH side.
PROCEDURE
1. INSTALL SIDE AIRBAG SENSOR ASSEMBLY
(a) Check that the ignition switch is OFF.
(b) Check that the cable is disconnec ...
On-vehicle Inspection
ON-VEHICLE INSPECTION
PROCEDURE
1. INSPECT FOR COOLANT LEAK
HINT:
The sliding surface inside the engine water pump assembly is lubricated
by engine coolant. As some engine coolant is discharged during normal operation,
engine coolant residue (solids) may be found on the drain plu ...
