Toyota Tacoma (2015-2018) Service Manual: Diagnostic Trouble Code Chart
DIAGNOSTIC TROUBLE CODE CHART
Main Body ECU (Multiplex Network Body ECU)|
DTC Code |
Detection Item |
See page |
|---|---|---|
|
B1206 |
P/W Master Switch Communication Stop |
|
|
B1273 |
Sliding Roof ECU Communication Stop |
|
|
B2321 |
Driver Side Door ECU Communication Stop |
|
|
B2322 |
Front Passenger Side Door ECU Communication Stop |
|
|
B2325 |
LIN Communication Bus Malfunction |
|
.gif)
|
DTC Code |
Detection Item |
See page |
|---|---|---|
|
B2785 |
Communication Malfunction between ECUs Connected by LIN |
|
|
B2786 |
No Response from Steering Lock ECU |
|
|
B278C |
Lost Communication with Power Source Control |
|
No Response from Steering Lock ECU (B2786)
DESCRIPTION
This DTC is stored when LIN communication between the certification ECU (smart
key ECU assembly) and steering lock ECU (steering lock actuator or upper bracket
assembly) stops for 10 ...
Sliding Roof ECU Communication Stop (B1273)
DESCRIPTION
This DTC is stored when LIN communication between the sliding roof ECU (sliding
roof drive gear sub-assembly) and main body ECU (multiplex network body ECU) stops
for 10 seconds or mo ...
Other materials:
Back-up Power Source Circuit
DESCRIPTION
The back-up power source circuit for the air conditioning amplifier assembly
is shown below. Power is supplied even when the ignition switch is off. The power
is used for diagnostic trouble code memory, etc.
WIRING DIAGRAM
CAUTION / NOTICE / HINT
NOTICE:
Inspect the fuses for ...
Customize Parameters
CUSTOMIZE PARAMETERS
PROCEDURE
1. CUSTOMIZE THEFT DETERRENT SYSTEM (w/ Wireless Door Lock System)
HINT:
The following items can be customized.
NOTICE:
When the customer requests a change in a function, first make sure that
the function can be customized.
Be sure to make a note ...
Disassembly
DISASSEMBLY
PROCEDURE
1. REMOVE STEERING INTERMEDIATE SHAFT ASSEMBLY
(a) Put matchmarks on the steering intermediate shaft assembly and steering main
shaft assembly.
(b) Remove the bolt and steering intermediate shaft assembly.
2. REMOVE UPPER STEERING COLUMN BRACKET WITH SWITCH ASSEMBLY (w ...
