Toyota Tacoma manuals

Toyota Tacoma 2015-2018 Service Manual: 2gr-fks Lubrication

Intake System
On-vehicle Inspection ON-VEHICLE INSPECTION PROCEDURE 1. INSPECT INTAKE SYSTEM (a) Check that there is no air suction at the points shown in the illustration. ...

Engine Oil Cooler
Components COMPONENTS ILLUSTRATION ILLUSTRATION ILLUSTRATION Inspection INSPECTION PROCEDURE 1. INSPECT OIL COOLER ASSEMBLY (a) Check the oil cooler assembly for damage a ...

Other materials:

On-vehicle Inspection
ON-VEHICLE INSPECTION PROCEDURE 1. INSPECT STEERING PAD (for Vehicle not Involved in Collision) (a) Perform a diagnostic system check (See page ). (b) With the steering pad installed on the vehicle, perform a visual check. If there are any defects as mentioned below, replace the steering pad ...

Engine Immobiliser System Circuit Short to Battery (B279A12)
DESCRIPTION When the communication line (IMI - EFIO) between the ECM and certification ECU (smart key ECU assembly) is stuck high, the ECM stores this DTC. DTC Code DTC Detection Condition Trouble Area DTC Output Confirmation Operation ...

Steering Angle Sensor Initialization Incomplete (C1439,C1445)
DESCRIPTION The skid control ECU (brake actuator assembly) acquires steering angle sensor zero point every time the ignition switch is turned ON and the vehicle is driven at 35 km/h (22 mph) or more for approximately 5 seconds. The ECU also stores the previous zero point. The steering angle ...

В© 2011-2019 Copyright www.ttguide.net