TTGuideTacoma manuals & technical reference
HomeLatestPopularManual indexSearchContacts
Toyota Tacoma (2015-2018) Service Manual / 2gr-fks Engine Control

Toyota Tacoma (2015-2018) Service Manual: 2gr-fks Engine Control

  • Accelerator Pedal
  • Air Fuel Ratio Sensor
  • Camshaft Oil Control Solenoid
    1. Components
    2. On-vehicle Inspection
    3. Inspection
    4. Removal
    5. Installation
  • Camshaft Oil Control Valve(for Exhaust Side Of Bank 1)
    1. Components
    2. On-vehicle Inspection
    3. Removal
    4. Installation
  • Camshaft Oil Control Valve(for Exhaust Side Of Bank 2)
    1. Components
    2. On-vehicle Inspection
    3. Installation
    4. Removal
  • Camshaft Oil Control Valve(for Intake Side Of Bank 1)
    1. Components
    2. On-vehicle Inspection
    3. Removal
    4. Installation
  • Camshaft Oil Control Valve(for Intake Side Of Bank 2)
    1. Components
    2. On-vehicle Inspection
    3. Removal
    4. Installation
  • Crankshaft Position Sensor
  • Ecm
  • Engine Coolant Temperature Sensor
Purge Valve
Components COMPONENTS ILLUSTRATION Inspection INSPECTION PROCEDURE 1. INSPECT PURGE VSV (a) Measure the resistance according to the value(s) in the table below. Text in Illu ...

Accelerator Pedal
Components COMPONENTS ILLUSTRATION On-vehicle Inspection ON-VEHICLE INSPECTION PROCEDURE 1. INSPECT ACCELERATOR PEDAL SENSOR ASSEMBLY (a) Connect the Techstream to the DLC3. (b) Turn the ...

Related Tacoma materials

Disassembly
DISASSEMBLY PROCEDURE 1. REMOVE TELEPHONE MICROPHONE ASSEMBLY Click here 2. REMOVE MICROPHONE CASE HINT: Use the same procedure for Double Cab. Click here 3. REMOVE NO. 1 ROOF WIRE (w/ Vanity Light) (a) w/ EC Mirror: (1) Remove the No. 1 roof wire. ...

Diagnosis System
DIAGNOSIS SYSTEM 1. DESCRIPTION (a) The transponder key ECU assembly controls the engine immobiliser system. The engine immobiliser system data and Diagnostic Trouble Codes (DTCs) can be read through the vehicle Data Link Connector 3 (DLC3). 2. CHECK DLC3 (a) Check the DLC3 (See page ). 3. ...

Reassembly
REASSEMBLY PROCEDURE 1. INSTALL FRONT AXLE HUB OIL SEAL (a) Using a brass bar and a hammer, install a new front axle hub oil seal. NOTICE: Do not damage the oil seal. 2. INSTALL FRONT AXLE WITH ABS ROTOR BEARING ASSEMBLY (a) Using SST and a press, install a new bearing onto the front axle ...

TTGuideToyota Tacoma manuals and technical documentation.
В© 2011-2026 www.ttguide.net