Toyota Tacoma (2015-2018) Service Manual: Removal

Toyota Tacoma (2015-2018) Service Manual / 2gr-fks Engine Control / Camshaft Oil Control Valve(for Intake Side Of Bank 2) / Removal

REMOVAL

CAUTION / NOTICE / HINT

NOTICE:

If one of the camshaft timing gear bolts is already removed, do not remove any other camshaft timing gear bolts.

PROCEDURE

1. REMOVE NO. 2 ENGINE UNDER COVER SUB-ASSEMBLY (w/ Off Road Package)

2. REMOVE NO. 1 ENGINE UNDER COVER SUB-ASSEMBLY

3. REMOVE CAMSHAFT TIMING OIL CONTROL SOLENOID ASSEMBLY

(See page 4. SET NO. 1 CYLINDER TO TDC/COMPRESSION )

4. SET NO. 1 CYLINDER TO TDC/COMPRESSION

(a) Turn the crankshaft clockwise to align the timing mark (cutout) on the crankshaft pulley assembly with the "0" timing mark on the timing chain cover assembly.

Text in Illustration

*a	"0" Timing Mark
*b	Timing Mark (Cutout)

(b) Check that the protrusion on the inside of the camshaft timing gear assembly is at the top.

Text in Illustration

*a	Protrusion

HINT:

If the protrusion is not at the top, rotate the crankshaft clockwise 360° and align the timing marks again.

5. REMOVE CAMSHAFT TIMING GEAR BOLT

(a) Using SST, hold the crankshaft pulley assembly.

SST: 09213-54015

91651-60855

SST: 09330-00021

(b) Remove the camshaft timing gear bolt.

NOTICE:

Replace with a new part if it is dropped or if it receives a strong impact.

On-vehicle Inspection

ON-VEHICLE INSPECTION PROCEDURE 1. INSPECT CAMSHAFT TIMING GEAR BOLT (a) Remove the camshaft timing oil control solenoid assembly (See page ). (b) Check that the plunger strokes when ...

Installation

INSTALLATION PROCEDURE 1. SET NO. 1 CYLINDER TO TDC/COMPRESSION 2. INSTALL CAMSHAFT TIMING GEAR BOLT NOTICE: There are different types of camshaft timing gearbolts. Make sure to check the id ...

Other materials:

Check For Intermittent Problems
CHECK FOR INTERMITTENT PROBLEMS 1. CHECK FOR INTERMITTENT PROBLEMS HINT: A momentary interruption (open circuit) in the connectors and/or wire harnesses between the sensors and ECUs can be detected using the ECU Data List function of the Techstream. (a) Turn the ignition switch off. (b) Con ...

Camper information
This information has been prepared in accordance with regulation issued by the National Highway Traffic Safety Administration of the U.S. Department of Transportation. It provides the purchasers and/or prospective purchasers of Toyota vehicles with information on truck-camper loading. Your Toy ...

Short in Curtain Shield Squib LH Circuit (B1835/58-B1838/58)
DESCRIPTION The driver side curtain shield squib circuit consists of the airbag sensor assembly and the curtain shield airbag assembly LH. The circuit signals the SRS to deploy when airbag deployment conditions are met. These DTCs are set when a malfunction is detected in the driver side curtai ...