Toyota Tacoma (2015-2018) Service Manual: Removal

Toyota Tacoma (2015-2018) Service Manual / 2gr-fks Engine Control / Camshaft Oil Control Valve(for Exhaust Side Of Bank 2) / Removal

REMOVAL

CAUTION / NOTICE / HINT

NOTICE:

If one of the camshaft timing gear bolts is already removed, do not remove any other camshaft timing gear bolts.

PROCEDURE

1. REMOVE NO. 2 ENGINE UNDER COVER SUB-ASSEMBLY (w/ Off Road Package)

2. REMOVE NO. 1 ENGINE UNDER COVER SUB-ASSEMBLY

3. REMOVE CAMSHAFT TIMING OIL CONTROL SOLENOID ASSEMBLY

(See page 4. SET NO. 1 CYLINDER TO TDC/COMPRESSION )

4. SET NO. 1 CYLINDER TO TDC/COMPRESSION

(a) Turn the crankshaft clockwise to align the timing mark (cutout) on the crankshaft pulley assembly with the "0" timing mark on the timing chain cover assembly.

Text in Illustration

*a	"0" Timing Mark
*b	Timing Mark (Cutout)

(b) Check that the end of the spring inside of the camshaft timing gear assembly is as shown in the illustration.

Text in Illustration

*a	Spring End

HINT:

If the end of the spring is not as shown in the illustration, rotate the crankshaft clockwise 360° and align the timing marks again.

5. REMOVE CAMSHAFT TIMING GEAR BOLT

(a) Using SST, hold the crankshaft pulley assembly.

SST: 09213-54015

91651-60855

SST: 09330-00021

(b) Remove the camshaft timing gear bolt.

NOTICE:

Replace with a new part if it is dropped or if it receives a strong impact.

Installation

INSTALLATION PROCEDURE 1. SET NO. 1 CYLINDER TO TDC/COMPRESSION 2. INSTALL CAMSHAFT TIMING GEAR BOLT NOTICE: There are different types of camshaft timing gear bolts. Make sure to check the i ...

Camshaft Oil Control Valve(for Intake Side Of Bank 1)

...

Other materials:

Transmitter ID not Received in Main Mode (C2126/26)
DESCRIPTION After all transmitter IDs are registered, DTC C2126/26 is stored in the tire pressure warning ECU and receiver and the tire pressure warning light blinks for 1 minute and then illuminates. When the tire pressure warning ECU and receiver successfully receives radio waves from all ...

Problem Symptoms Table
PROBLEM SYMPTOMS TABLE HINT: Use the table below to help determine the cause of problem symptoms. If multiple suspected areas are listed, the potential causes of the symptoms are listed in order of probability in the "Suspected Area" column of the table. Check each sy ...

Invalid Data Received from Deceleration Sensor (C1442,C1443)
DESCRIPTION The airbag sensor assembly has a built-in yaw rate and acceleration sensor. The skid control ECU (brake actuator assembly) receives signals from the yaw rate and acceleration sensor (airbag sensor assembly) via the CAN communication system. DTC No. Detection ...