Toyota Tacoma (2015-2018) Service Manual: Engine Immobiliser System(w/ Smart Key System)
- Parts Location
- Precaution
- System Description
- System Diagram
- How To Proceed With Troubleshooting
- Problem Symptoms Table
- Registration
- Diagnosis System
- Dtc Check / Clear
- Terminals Of Ecu
- Data List / Active Test
- Diagnostic Trouble Code Chart
- Engine Immobiliser System Incorrect Assembly (B279C95)
- Antenna Coil Open / Short (B2784)
- Engine Immobiliser System Signal (Some Circuit Quantity, Reported via Serial Data) Invalid (B279986)
- Malfunction of ID-BOX Recognition (B278D)
- Engine Immobiliser System Circuit Short to Battery (B279A12)
- Short to GND in Immobiliser System Power Source Circuit (B278A)
- Security Indicator Light Does not Blink
- Immobiliser System does not Operate Properly
Certification Ecu
Components
COMPONENTS
ILLUSTRATION
Installation
INSTALLATION
PROCEDURE
1. INSTALL CERTIFICATION ECU (SMART KEY ECU ASSEMBLY)
(a) Install the certification ECU (smart key ECU assembly) wit ...
Parts Location
PARTS LOCATION
ILLUSTRATION
ILLUSTRATION
...
Other materials:
Portable Player cannot be Registered
CAUTION / NOTICE / HINT
HINT:
Some versions of "Bluetooth" compatible audio players may not function, or the
function may be limited using the navigation receiver assembly, even if the portable
audio player itself can play files (See page ).
PROCEDURE
1.
CHE ...
Dtc Check / Clear
DTC CHECK / CLEAR
1. CHECK DTC (CHECK USING TECHSTREAM)
(a) Connect the Techstream to the DLC3.
(b) Turn the ignition switch to ON.
(c) Turn the Techstream on.
(d) Enter the following menus: Body Electrical / Navigation System / Trouble
Codes.
(e) Check for DTCs, and then write them down.
( ...
Short to +B in Outer Mirror Indicator(Slave) (C1AB1)
DESCRIPTION
This DTC is stored when the blind spot monitor sensor RH detects a +B short in
the blind spot monitor indicator RH.
DTC Code
DTC Detection Condition
Trouble Area
C1AB1
With the blind spot monitor main switch assembly (warni ...
