Toyota Tacoma (2015-2018) Service Manual: Engine Immobiliser
- Certification Ecu
- Engine Immobiliser System(w/ Smart Key System)
- Parts Location
- Precaution
- System Description
- System Diagram
- How To Proceed With Troubleshooting
- Problem Symptoms Table
- Registration
- Diagnosis System
- Dtc Check / Clear
- Terminals Of Ecu
- Data List / Active Test
- Diagnostic Trouble Code Chart
- Engine Immobiliser System Incorrect Assembly (B279C95)
- Antenna Coil Open / Short (B2784)
- Engine Immobiliser System Signal (Some Circuit Quantity, Reported via Serial Data) Invalid (B279986)
- Malfunction of ID-BOX Recognition (B278D)
- Engine Immobiliser System Circuit Short to Battery (B279A12)
- Short to GND in Immobiliser System Power Source Circuit (B278A)
- Security Indicator Light Does not Blink
- Immobiliser System does not Operate Properly
- Engine Immobiliser System(w/o Smart Key System)
- Parts Location
- Precaution
- System Description
- System Diagram
- How To Proceed With Troubleshooting
- Problem Symptoms Table
- Registration
- Diagnosis System
- Dtc Check / Clear
- Data List / Active Test
- Diagnostic Trouble Code Chart
- Theft Deterrent System Communication Line High Fixation (B279A,B279A12)
- Theft Deterrent System Presence Detection (B279C,B279C95)
- Engine Immobiliser System Malfunction (B2799,B279986)
- Push Switch / Key Unlock Warning Switch Malfunction (B2780)
- Antenna Coil Open / Short (B2784)
- Transponder Chip Malfunction (B2793,B2794,B2797,B2798)
- Engine does not Start because No Initial Combustion
- Engine does not Start but Initial Combustion Occurs
- Key Cannot be Registered
- Security Indicator Light Does not Blink
- Transponder Key Amplifier
- Transponder Key Ecu
Tonneau Cover Assembly
Removal
REMOVAL
PROCEDURE
1. REMOVE TOP COVER SUB-ASSEMBLY
(a) Open the cover.
(b) Remove the bolt and top cover sub-assembly.
2. REMOVE RE ...
Certification Ecu
Components
COMPONENTS
ILLUSTRATION
Installation
INSTALLATION
PROCEDURE
1. INSTALL CERTIFICATION ECU (SMART KEY ECU ASSEMBLY)
(a) Install the certification ECU (smart key ECU assembly) wit ...
Other materials:
Steering Angle Sensor Power Source Voltage Malfunction (C1432)
DESCRIPTION
The skid control ECU (brake actuator assembly) outputs this DTC when it receives
a sensor power source malfunction signal from the steering angle sensor.
DTC No.
Detection Item
DTC Detection Condition
Trouble Area
C1432
...
Inspection
INSPECTION
PROCEDURE
1. INSPECT FRONT NO. 2 SPEAKER ASSEMBLY
(a) When there is a malfunction such as noise from a speaker or no sound at all,
replace the speaker with a new one and check that the malfunction disappears.
OK:
Malfunction disappears.
HINT:
Connect the connectors to th ...
Bleeding
BLEEDING
CAUTION / NOTICE / HINT
NOTICE:
Wash off brake fluid immediately if it comes in contact with any painted surface.
HINT:
If any work is performed on the clutch system or if there is thought to be air
in the clutch lines, bleed air from the clutch hydraulic system.
PROCEDURE
1. FILL ...
