DIAGNOSIS SYSTEM
1. DESCRIPTION
(a) The certification ECU (smart key ECU assembly) and ECM control the vehicle engine immobiliser system functions. Engine immobiliser system data and Diagnostic Trouble Codes (DTCs) can be read through the vehicle Data Link Connector 3 (DLC3).
In some cases, a malfunction may be occurring in the engine immobiliser system even though the security indicator light is not illuminated.
When the system seems to be malfunctioning, use the Techstream to check for malfunctions and perform repairs.
2. CHECK DLC3
(a) Check the DLC3 (See page ).
3. INSPECT BATTERY VOLTAGE
(a) Measure the battery voltage.
Standard Voltage:
11 to 14 V
If the voltage is below 11 V, recharge or replace the battery.
4. START FUNCTION PROBLEM SYMPTOMS
Symptom |
Suspected Area |
Component Malfunction |
Possible Output DTCs |
Related Data List Item |
---|---|---|---|---|
Engine cannot be started*1 |
Certification ECU (smart key ECU assembly) |
Open or short circuit inside ECU |
|
|
ECM |
Open or short circuit inside ECU |
|
EFI Code Receive |
|
SFI system |
ECM incompatible with installed engine immobiliser system |
B279C |
|
|
Power source mode cannot be changed*1 |
Engine switch |
Open or short circuit inside switch |
B278A |
|
Certification ECU (smart key ECU assembly) |
Open or short circuit inside ECU |
|
|
|
Steering lock lock/unlock not possible*2 |
Steering lock ECU (steering lock actuator or upper bracket) |
|
|
|
Removal
REMOVAL
PROCEDURE
1. REMOVE FRONT DOOR SCUFF PLATE LH
for Double Cab:
Click here
for Access Cab:
Click here
2. REMOVE COWL SIDE TRIM BOARD LH
Click here
3. REMOVE INSTRUMENT CLUSTER CENTER FINISH PANEL SUB-ASSEMBLY
Click here
4. REMOVE INSTRUMENT CLUSTER FINISH PANEL ASSEMBLY
Cli ...
Certification Ecu
Components
COMPONENTS
ILLUSTRATION
Installation
INSTALLATION
PROCEDURE
1. INSTALL CERTIFICATION ECU (SMART KEY ECU ASSEMBLY)
(a) Install the certification ECU (smart key ECU assembly) with the 2 nuts.
Torque:
6.5 N·m {66 kgf·cm, 58 in·lbf}
(b) Engage the clamp to install the wire ...
Precaution
PRECAUTION
1. PRECAUTIONS FOR REFRIGERANT HFO-1234yf (R1234yf)
(a) Compatibility
(1) The parts used in the refrigerant cycle, the compressor oil, etc. of the
HFO-1234yf (R1234yf) system are not compatible with the conventional HFC-134a (R134a)
system.
(b) HFO-1234yf (R1234yf) Refrigerant
(1 ...