Toyota Tacoma (2015-2018) Service Manual: Charging System
- Precaution
- Parts Location
- System Diagram
- How To Proceed With Troubleshooting
- Problem Symptoms Table
- Diagnosis System
- Terminals Of Ecm
- Dtc Check / Clear
- Freeze Frame Data
- Data List / Active Test
- Fail-safe Chart
- Diagnostic Trouble Code Chart
- On-vehicle Inspection
- Lost Communication with Alternator Missing Message (P161A87)
- Charging Failure
- Noise Occurs from V-ribbed Belt or Generator Assembly
2gr-fks Charging
...
Precaution
PRECAUTION
1. Check that the battery cables are connected to the correct terminals.
2. Disconnect the battery cables when the battery is given a quick charge.
3. Do not perform tests with a high vo ...
Other materials:
Inspection
INSPECTION
PROCEDURE
1. INSPECT AUTO HIGH BEAM SWITCH
*a
Component without harness connected
(Auto High Beam Switch)
(a) Check the resistance.
(1) Measure the resistance according to the value(s) in the table below.
Standard Resistance:
Tester C ...
Disassembly
DISASSEMBLY
PROCEDURE
1. REMOVE STEERING GEAR OUTLET RETURN TUBE
(a) Using a union nut wrench, remove the steering gear outlet return tube.
2. REMOVE STEERING TURN PRESSURE TUBE
(a) Using a union nut wrench, remove the 2 pressure tubes.
(b) Remove the 4 O-rings from the pressure tubes.
3. ...
Open or Short in Rear Speed Sensor RH Circuit (C1407,C1408)
DESCRIPTION
Refer to DTCs C1403 and C1404 (See page ).
DTC No.
Detection Item
DTC Detection Condition
Trouble Area
C1407
Open or Short in Rear Speed Sensor RH Circuit
Either of the following is detected:
...
