Toyota Tacoma (2005–2015) Owners Manual: Front seats
Bench type seat
Seat position adjustment lever
Separated type seats
Seat position adjustment lever
Driver’s seat lumbar support adjustment
knob (if equipped)
Seatback angle adjustment lever
- Moving passenger’s seat for rear seat entry (if equipped)
- Folding seatback (Bench type seat)
- Folding passenger’s seat (vehicles with seatback table)
- Active head restraints (Access Cab and Double Cab models only)
Moving passenger’s seat for rear seat entry (if equipped)
Lift the seatback angle adjusting lever or press the pedal behind the seatback.
The seat will slide forward.
Move the seat to the front-most position.
■ After passengers are in the vehicle ...
Other materials:
Blind Spot Monitor Slave Module Beam Axis Inspection Incomplete (C1ABC)
DESCRIPTION
This DTC is stored when a beam axis inspection has not been performed for the
blind spot monitor sensor RH.
HINT:
This DTC is always stored after replacing a blind spot monitor sensor. The purpose
of this DTC is to ensure that beam axis inspection is performed. Completing the
be ...
Terminals Of Ecu
TERMINALS OF ECU
1. CHECK DRIVER SIDE JUNCTION BLOCK AND MAIN BODY ECU (MULTIPLEX NETWORK BODY
ECU)
(a) Disconnect the MB main body ECU (multiplex network body ECU) connectors.
(b) Measure the voltage and resistance according to the value(s) in the table
below.
HINT:
Measure the values on ...
VSC OFF Switch Circuit
DESCRIPTION
The skid control ECU assembly is connected to the combination meter assembly
via CAN communication.
Pressing the VSC OFF switch turns off TRAC operation, and pressing and holding
this switch turns off TRAC and VSC operation.
If TRAC and VSC operations are turned off, the TRAC OFF ...
