Toyota Tacoma manuals

Toyota Tacoma Owners Manual: Folding seatback (Bench type seat)

Pull the seatback lock release lever and fold down the seatback.

Pull the seatback lock release lever and fold down the seatback.

Hold the lever until you have swung the seatback forward slightly.

Moving passenger’s seat for rear seat entry (if equipped)
Lift the seatback angle adjusting lever or press the pedal behind the seatback. The seat will slide forward. Move the seat to the front-most position. ■ After passengers are in the vehicle ...

Folding passenger’s seat (vehicles with seatback table)
Pull the seatback angle adjusting lever and raise the seatback to its upright position. Pull the seatback folding lever and fold the seatback down. ...

Other materials:

Check Bus 5 Line for Short to GND
DESCRIPTION There may be a short circuit between one of the CAN bus lines and GND when there is no resistance between terminal 15 (CA5H) of the central gateway ECU (network gateway ECU) and terminal 4 (CG) of the DLC3, or terminal 16 (CA5L) of the central gateway ECU (network gateway ECU) and ...

Removal
REMOVAL CAUTION / NOTICE / HINT HINT: Use the same procedure for the RH and LH sides. The procedure described below is for the LH side. PROCEDURE 1. REMOVE FRONT DOOR GLASS RUN 2. REMOVE FRONT DOOR GLASS OUTER WEATHERSTRIP ASSEMBLY (See page ) 3. REMOVE NO. 1 BLAC ...

Pressure Control Solenoid "C" Circuit Open (P079513)
DESCRIPTION Changing from 1st to 6th is performed by the ECM turning shift solenoid valves SL1, SL2, SL3 and SL4 on and off. If an open or short circuit occurs in any of the shift solenoid valves, the ECM controls the remaining normal shift solenoid valves to allow the vehicle to be operated ...

© 2011-2022 Copyright www.ttguide.net