TTGuideTacoma manuals & technical reference
HomeAbout carFAQReviewLatestPopularManual indexSearchContacts
Toyota Tacoma (2015-2018) Service Manual / Cruise Control / Dynamic Radar Cruise Control System(for 2gr-fks)

Toyota Tacoma (2015-2018) Service Manual: Dynamic Radar Cruise Control System(for 2gr-fks)

  • Precaution
  • Definition Of Terms
  • Parts Location
  • System Diagram
  • How To Proceed With Troubleshooting
  • System Description
  • Operation Check
  • Road Test
  • Diagnosis System
  • Problem Symptoms Table
  • Terminals Of Ecu
  • Dtc Check / Clear
  • Freeze Frame Data
  • Diagnostic Trouble Code Chart
  • Fail-safe Chart
  • Vehicle Control History
  • Communication Error from ECM to VSC Invalid Serial Data Received (P163181)
  • Lost Communication with ECM / PCM "A" (U0100,U0125,U0126,U0129)
  • Lost Communication With ECM/PCM "A" Missing Message (U010087,U010487,U012287)
  • Brake System (P157800)
  • Cruise Control Input Processor (P160700)
  • Communication Error from VSC to ECM Invalid Serial Data Received (P163081)
  • Brake Switch "A" Signal Compare Failure (P057162)
  • Cruise Control System Internal Failure (P057504,P057549)
  • Skid Control Buzzer Circuit (C1A4A)
  • Radar Cruise Control Presence Determination Malfunction (Engine / HV) (C1A52)
  • Brake Switch "A" Circuit Open (P057113)
  • Front Radar Sensor (C1A10)
  • Front Radar Sensor Incorrect Axial Gap (C1A11,C1A14)
  • Front Radar Sensor Region Code Mismatch (C1A0A)
  • Vehicle Information Not Obtained (C1A02)
  • Clutch Switch Circuit
  • Cruise Control Switch Circuit
  • Cruise Main Indicator Light Circuit
  • Distance Control Switch Circuit
  • Cruise SET Indicator Light Circuit
  • Neutral Position Switch Circuit
← Previous articleTC and CG Terminal CircuitDESCRIPTION The DLC3 circuit enables reading of Diagnostic Trouble Codes (DTCs) with no Techstream by connecting terminals TC and CG of the DLC3 connector.…→ Next articlePrecautionPRECAUTION IGNITION SWITCH EXPRESSIONS (a) The type of ignition switch used on this model differs according to the specifications of the vehicle. The expre…
Related Tacoma materials

Removal
REMOVAL PROCEDURE 1. REMOVE FRONT NO. 2 EXHAUST PIPE ASSEMBLY (for 2GR-FKS) 2. REMOVE PROPELLER SHAFT HEAT INSULATOR BRACKET SUB-ASSEMBLY (a) Remove the 2 bolts and propeller shaft heat insulator bracket. 3. REMOVE FRONT PROPELLER SHAFT ASSEMBLY (a) Place matchmarks on the propeller sh ...

Tire Inspection and Wear Checks
Inspect the tires regularly to determine whether any treadwear indicators have become visible. These indicators provide a clear reference for judging when the tread has worn to the point where replacement is required. Examine the entire tread surface for irregular wear patterns as well, including no ...

Dtc Check / Clear
DTC CHECK / CLEAR 1. CHECK DTC (a) Connect the Techstream to the DLC3. (b) Turn the ignition switch to ON. (c) Turn the Techstream on. (d) Enter the following menus: Body Electrical / Trouble Codes. (e) Check DTCs and then write them down. HINT: Refer to the Techstream operator's manual ...

TTGuideToyota Tacoma manuals and technical documentation.
В© 2011-2026 www.ttguide.net - 0.0619