TTGuideTacoma manuals & technical reference
Toyota Tacoma (2015-2018) Service Manual / Cruise Control / Cruise Control System(for 2gr-fks) / TC and CG Terminal Circuit

Toyota Tacoma (2015-2018) Service Manual: TC and CG Terminal Circuit

DESCRIPTION

The DLC3 circuit enables reading of Diagnostic Trouble Codes (DTCs) with no Techstream by connecting terminals TC and CG of the DLC3 connector.

Stored DTCs are displayed in blinking patterns of the CRUISE MAIN indicator light located on the combination meter.

WIRING DIAGRAM

HINT:

HINT:

When a particular warning light blinks continuously, a ground short in the wiring of terminal TC of the DLC3 or an internal ground short in the relevant ECU is suspected.

PROCEDURE

1.

CHECK HARNESS AND CONNECTOR (TC of DLC3 - ECM)

(a) Disconnect the E21 ECM connector.

(b) Measure the resistance according to the value(s) in the table below.

Standard Resistance:

Tester Connection

Condition

Specified Condition

D4-13 (TC) - E14-20 (TC)

Always

Below 1 Ω

(c) Reconnect the ECM connector.

NG

REPAIR OR REPLACE HARNESS OR CONNECTOR
OK

2.

CHECK HARNESS AND CONNECTOR (TC of DLC3 - BODY GROUND)

(a) Measure the resistance according to the value(s) in the table below.

Standard Resistance:

Tester Connection

Condition

Specified Condition

TC (D4-13) - Body ground

Always

10 kΩ or higher
Text in Illustration

*1

DLC3
NG

REPAIR OR REPLACE HARNESS OR CONNECTOR
OK

3.

CHECK HARNESS AND CONNECTOR (CG of DLC3 - BODY GROUND)

(a) Measure the resistance according to the value(s) in the table below.

Standard Resistance:

Tester Connection

Condition

Specified Condition

CG (D4-4) - Body ground

Always

Below 1 Ω
Text in Illustration

*1

DLC3
OK

REPLACE ECM

NG

REPAIR OR REPLACE HARNESS OR CONNECTOR
    Related Tacoma materials

    Rear Left Sensor Malfunction (C1AE6)
    DESCRIPTION The No. 1 ultrasonic sensor (rear corner sensor LH) is installed on the rear bumper. The ECU detects obstacles based on signals received from the No. 1 ultrasonic sensor (rear corner sensor LH). If the No. 1 ultrasonic sensor (rear corner sensor LH) has an open circuit or other ma ...

    Installation
    INSTALLATION PROCEDURE 1. INSTALL RADIATOR ASSEMBLY (a) Engage the 2 hooks and temporarily install the radiator assembly to the radiator support sub-assembly. (b) Install the radiator assembly with the 4 bolts. Torque: 18 N·m {184 kgf·cm, 13 ft·lbf} 2. INSTALL FAN SHROUD (a) Install th ...

    Sound of Portable Player cannot be Heard from Speakers or Sound is Low
    PROCEDURE 1. CHECK PORTABLE PLAYER SETTINGS (a) Check the portable player settings. (1) Check that the volume is not set to "0". (2) Check that the mute is off. (b) Check that the sound of the portable player can be heard from the speakers. OK: Sound ...