DESCRIPTION
When the dynamic radar cruise control system is turned on using the cruise control main switch (ON-OFF button), the cruise control indicator (vehicle-to-vehicle distance control mode) illuminates. The ECM uses this and other indicators to indicate the control condition (presence or absence of a preceding vehicle, vehicle-to-vehicle distance, and set vehicle speed) and fail-safe state via CAN communication.
CAUTION / NOTICE / HINT
NOTICE:
- Before replacing the ECM, refer to Registration.
w/o Smart Key System: Click here
.gif)
w/ Smart Key System: Click here
- When replacing the combination meter assembly, always replace it with a new one. If a combination meter assembly which was installed to another vehicle is used, the information stored in it will not match the information from the vehicle and a DTC may be stored.
PROCEDURE
|
1. |
PERFORM ACTIVE TEST USING TECHSTREAM (METER DISPLAY 1) |
(a) Connect the Techstream to the DLC3.
(b) Turn the ignition switch to ON.
(c) Turn the Techstream on.
(d) Enter the following menus: Body Electrical / Combination Meter / Active Test.
(e) Perform the Active Test according to the display on the Techstream.
Body Electrical > Combination Meter > Active Test
|
Tester Display |
Measurement Item |
Control Range |
Diagnostic Note |
|---|---|---|---|
|
Meter Display 1 |
Multi-information display |
OFF, 6 to 0 or All |
- |
|
Result |
Proceed to |
|---|---|
|
The multi-information display in the combination meter assembly turns on or off according to the operation of the Active Test. |
A |
|
The multi-information display in the combination meter assembly does not turn on or off according to the operation of the Active Test. |
B |
| B | .gif) |
GO TO METER / GAUGE SYSTEM |
|
.gif)
|
2. |
READ VALUE USING TECHSTREAM (CRUISE READY MAIN-CPU, CRUISE READY SUB-CPU, CRUISE INDICATOR) |
(a) Enter the following menus: Powertrain / Radar Cruise1 / Data List.
(b) Read the Data List according to the display on the Techstream.
Powertrain > Radar Cruise1 > Data List
|
Tester Display |
Measurement Item |
Range |
Normal Condition |
Diagnostic Note |
|---|---|---|---|---|
|
Cruise Ready Main-CPU |
Cruise control system standby condition |
ON or OFF |
Each time cruise control main switch (ON-OFF button) is pushed, ON or OFF changes |
- |
|
Cruise Ready Sub-CPU |
Cruise control system standby condition |
ON or OFF |
Each time cruise control main switch (ON-OFF button) is pushed, ON or OFF changes |
- |
|
Cruise Indicator |
Cruise control indicator status |
ON or OFF |
ON: Cruise control indicator illuminates OFF: Cruise control indicator turns off |
- |
|
Result |
Proceed to |
|---|---|
|
The cruise control indicator illuminates and turns off according to the operation of the cruise control main switch (ON-OFF button). |
A |
|
The cruise control indicator does not illuminate but the Data List item Cruise Indicator changes according to the operation of the cruise control main switch (ON-OFF button). |
B |
|
The cruise control indicator does not illuminate and the Data List item Cruise Indicator does not change according to the operation of the cruise control main switch (ON-OFF button). |
C |
| A | |
PROCEED TO NEXT SUSPECTED AREA SHOWN IN PROBLEM SYMPTOMS TABLE |
| B | |
REPLACE COMBINATION METER ASSEMBLY |
| C | |
REPLACE ECM |
