TTGuideTacoma manuals & technical reference
Toyota Tacoma (2015-2018) Service Manual / Cruise Control / Dynamic Radar Cruise Control System(for 2gr-fks) / Brake System (P157800)

Toyota Tacoma (2015-2018) Service Manual: Brake System (P157800)

DESCRIPTION

This DTC is stored when a malfunction is detected in the vehicle stability control system.

DTC No.

Detection Item

DTC Detection Condition

Trouble Area

MIL

P157800

Brake System

While the ignition switch is ON and the dynamic radar cruise control system is operating, a malfunction in the vehicle stability control system is detected for 0.2 seconds or more.
  • Vehicle stability control system
  • ECM

Does not come on

CAUTION / NOTICE / HINT

NOTICE:

  • First check the CAN communication system by following How to Proceed with Troubleshooting. After checking that there are no malfunctions in the CAN communication system, proceed with troubleshooting

    Click here Click here

    Click here

  • Before replacing the ECM, refer to Registration.

    w/o Smart Key System: Click here w/ Smart Key System: Click here

    w/ Smart Key System: Click here

PROCEDURE

1.

CHECK FOR DTCs (VEHICLE STABILITY CONTROL SYSTEM)

(a) Check for DTCs.

  • for Hydraulic Brake Booster: Click here for Vacuum Brake Booster: Click here
  • for Vacuum Brake Booster: Click here

Result

Proceed to

DTCs are not output

A

DTCs are output (for Hydraulic Brake Booster)

B

DTCs are output (for Vacuum Brake Booster)

C
B

GO TO VEHICLE STABILITY CONTROL SYSTEM

C

GO TO VEHICLE STABILITY CONTROL SYSTEM

A

2.

CHECK FOR DTCs (CRUISE CONTROL SYSTEM)

(a) Clear the DTCs.

Click here (b) Perform the following procedure.

(b) Perform the following procedure.

HINT:

If the following procedure is not performed, the previously output DTC cannot be detected.

  1. Turn the ignition switch to ON.
  2. Turn the dynamic radar cruise control system on using the cruise control main switch.
  3. Wait for 1 second or more.

(c) Check for DTCs.

Click here

Result

Proceed to

DTC P157800 is not output

A

DTC P157800 is output

B
A

USE SIMULATION METHOD TO CHECK

B

REPLACE ECM

    Related Tacoma materials

    Disassembly
    DISASSEMBLY CAUTION / NOTICE / HINT HINT: Use the same procedure for both the LH and RH sides. The procedure described below is for the LH side. PROCEDURE 1. REMOVE FOG LIGHT BULB (a) Turn the fog light bulb in the direction indicated by the arrow in the illust ...

    Parts Location
    PARTS LOCATION ILLUSTRATION ILLUSTRATION ILLUSTRATION ILLUSTRATION ILLUSTRATION ...

    Center Airbag Sensor Assembly Malfunction (B1000/31)
    DESCRIPTION The airbag sensor assembly consists of a deceleration sensor, safing sensor, drive circuit, diagnosis circuit, ignition control, etc. If the airbag sensor assembly receives signals from the deceleration sensor, it determines whether or not the SRS should be activated. DTC B1000/31 ...