Slave Module Horizontal Axis Misalignment (C1AC2)
DESCRIPTION
This DTC is stored when the angle of the blind spot monitor sensor RH deviates
more than the allowable range from the horizontal axis.
HINT:
If drum tester such as a speedometer tester, brake/speedometer combination tester
or chassis dynamometer is used with the blind spot monitor ...
Reassembly
REASSEMBLY
PROCEDURE
1. TEMPORARILY TIGHTEN FRONT DISC BRAKE BLEEDER PLUG
(a) Provisionally tighten the bleeder plug to the disc brake cylinder.
(b) Install the bleeder plug cap onto the bleeder plug.
2. INSTALL PISTON SEAL
(a) Apply lithium soap base glycol grease to 4 new piston s ...
Calibration
CALIBRATION
1. DESCRIPTION
(a) After replacing the VSC relevant components or performing "Front wheel alignment
adjustment", clearing and reading the sensor calibration data are necessary.
(b) Follow the chart to perform calibration.
Replacing Parts
Necessary Op ...