Toyota Tacoma manuals

Toyota Tacoma (2005–2015) Owners Manual: Steering wheel

The steering wheel can be adjusted to a comfortable position.

Hold the steering wheel and press the lever down.

Hold the steering wheel and press the lever down.

Adjust to the ideal position by moving the steering wheel horizontally and vertically.

Adjust to the ideal position by moving the steering wheel horizontally and vertically.

After adjustment, pull the lever up to secure the steering wheel.

CAUTION

■Caution while driving

Do not adjust the steering wheel while driving.

Doing so may cause the driver to mishandle the vehicle and an accident may occur resulting in death or serious injury.

■After adjusting the steering wheel

Make sure that the steering wheel is securely locked.

Otherwise, the steering wheel may move suddenly, possibly causing an accident and resulting in death or serious injury.

Seat belts
Make sure that all occupants are wearing their seat belts before driving the vehicle. ■ Correct use of the seat belts ● Extend the shoulder belt so that it comes fully over the shoul ...

Anti-glare inside rear view mirror
Glare from the headlights of vehicles behind can be reduced by using the following functions. Manual anti-glare inside rear view mirror Normal position Anti-glare position Auto anti-glare ...

Other materials:

Differential Oil
Adjustment ADJUSTMENT PROCEDURE 1. INSPECT DIFFERENTIAL OIL (a) Stop the vehicle on a level place. (b) Remove the differential filler plug and gasket. (c) Check that the oil level is within 5 mm (0 to 0.20 in.) of the bottom of the filler plug opening. NOTICE: Excessively large ...

On-vehicle Inspection
ON-VEHICLE INSPECTION PROCEDURE 1. INSPECT STEERING PAD (for Vehicle not Involved in Collision) (a) Perform a diagnostic system check (See page ). (b) With the steering pad installed on the vehicle, perform a visual check. If there are any defects as mentioned below, replace the steering pad ...

Combination Meter ECU Communication Stop Mode
DESCRIPTION Detection Item Symptom Trouble Area Combination Meter ECU Communication Stop Mode Either condition is met: Communication stop for "Combination Meter" is indicated on the "Communication Bus Ch ...

© 2011-2025 Copyright www.ttguide.net