Toyota Tacoma (2015-2018) Service Manual: Vehicle Speed Sensor (C1A45)

Toyota Tacoma (2015-2018) Service Manual / Park Assist / Monitoring / Blind Spot Monitor System / Vehicle Speed Sensor (C1A45)

DESCRIPTION

The blind spot monitor sensor receives vehicle speed signals from the skid control ECU (brake actuator assembly) via CAN communication.

DTC Code	DTC Detection Condition	Trouble Area
C1A45	A fail flag is transmitted from the skid control ECU (brake actuator assembly).	Vehicle stability control system Blind spot monitor sensor LH Blind spot monitor sensor RH

CAUTION / NOTICE / HINT

NOTICE:

When checking for DTCs, make sure that the blind spot monitor main switch assembly (warning canceling switch assembly) is on.

PROCEDURE

1.	CHECK DTC (VEHICLE STABILITY CONTROL SYSTEM)

(a) Check for vehicle stability control system DTCs.

for Hydraulic Brake Booster (See page )
for Vacuum Brake Booster (See page )

OK:

Vehicle stability control system DTCs are not output.

Result

Result	Proceed to
OK	A
NG (for Hydraulic Brake Booster)	B
NG (for Vacuum Brake Booster)	C

GO TO VEHICLE STABILITY CONTROL SYSTEM

CHECK DTC

(a) Clear the DTCs (See page (b) Recheck for DTCs and check if the same DTC is output again (See page ).

(b) Recheck for DTCs and check if the same DTC is output again (See page Result ).

Result

Result	Proceed to
No DTC is output	A
DTC is output from the blind spot monitor sensor LH (master)	B
DTC is output from the blind spot monitor sensor RH (slave)	C

USE SIMULATION METHOD TO CHECK

REPLACE BLIND SPOT MONITOR SENSOR LH

REPLACE BLIND SPOT MONITOR SENSOR RH

Short to +B in Outer Mirror Indicator(Slave) (C1AB1)

DESCRIPTION This DTC is stored when the blind spot monitor sensor RH detects a +B short in the blind spot monitor indicator RH. DTC Code DTC Detection Condition Tr ...

Short to +B in Outer Mirror Indicator(Master) (C1AB0)

DESCRIPTION This DTC is stored when the blind spot monitor sensor LH detects a +B short in the blind spot monitor indicator LH. DTC Code DTC Detection Condition Tr ...

Other materials:

Customize Parameters
CUSTOMIZE PARAMETERS PROCEDURE 1. CUSTOMIZE THEFT DETERRENT SYSTEM (w/ Wireless Door Lock System) HINT: The following items can be customized. NOTICE: When the customer requests a change in a function, first make sure that the function can be customized. Be sure to make a note ...

Removal
REMOVAL PROCEDURE 1. DRAIN TRANSFER OIL 2. REMOVE FRONT PROPELLER SHAFT ASSEMBLY 3. REMOVE PROPELLER WITH CENTER BEARING SHAFT ASSEMBLY 4. SUPPORT TRANSMISSION ASSEMBLY 5. REMOVE NO. 3 FRAME CROSSMEMBER SUB-ASSEMBLY 6. REMOVE REAR NO. 1 ENGINE MOUNTING INSULATOR 7. SUPPO ...

Installation
INSTALLATION CAUTION / NOTICE / HINT HINT: Use the same procedure for both the RH and LH sides. The procedure described below is for the LH side. PROCEDURE 1. INSTALL FRONT SHOULDER BELT ANCHOR ADJUSTER ASSEMBLY (a) As shown in the illustration, engage the 2 guides ...