Installation
INSTALLATION
PROCEDURE
1. INSPECT FRONT PROPELLER SHAFT ASSEMBLY (with Grease Fitting)
HINT:
When replacing the spider bearing, make sure that the grease fitting assembly
hole is facing in the d ...
Components
COMPONENTS
ILLUSTRATION
...
Related Tacoma materials
Problem Symptoms Table
PROBLEM SYMPTOMS TABLE
HINT:
Proceed to the troubleshooting for each circuit in the table below.
Symptom
Suspected Area
See page
Passenger seat occupant conditions and displayed passenger airbag ON/OFF
indicator do not correspond
Tr ...
Acceleration Sensor Power Supply Voltage Malfunction (C1381)
DESCRIPTION
The skid control ECU (master cylinder solenoid) receives signals from the yaw
rate and acceleration (airbag sensor assembly) via the CAN communication system.
The airbag sensor assembly has a built-in yaw rate and acceleration sensor and
detects the vehicle's condition using 2 ...
If the engine will not start
If the engine still does not start after following the correct starting procedure
(→P. 141) or releasing the steering lock (→P. 142), confirm the following points.
■ The engine will not start even when the starter motor operates normally.
One of the following may be the cause o ...