Toyota Tacoma manuals

Toyota Tacoma (2015-2018) Service Manual: Installation

INSTALLATION

PROCEDURE

1. INSTALL CHILD RESTRAINT SEAT ANCHOR BRACKET SUB-ASSEMBLY

HINT:

Use the same procedure for the side.

(a) Install the child restraint seat anchor bracket sub-assembly with the 2 bolts.

Torque:

30 N·m {306 kgf·cm, 22 ft·lbf}

(b) Reinstall the floor carpet.

2. INSTALL REAR SEAT HEADREST ASSEMBLY

(a) Install the 2 rear seat headrest assemblies with the 8 bolts.

Torque:

20 N·m {204 kgf·cm, 15 ft·lbf}

3. INSTALL NO. 3 ROOM PARTITION COVER

4. INSTALL NO. 4 ROOM PARTITION COVER LH 4. INSTALL NO. 4 ROOM PARTITION COVER LH

4. INSTALL NO. 4 ROOM PARTITION COVER LH

5. INSTALL NO. 4 ROOM PARTITION COVER RH 5. INSTALL NO. 4 ROOM PARTITION COVER RH

5. INSTALL NO. 4 ROOM PARTITION COVER RH

6. INSTALL BACK PANEL TRIM 6. INSTALL BACK PANEL TRIM

6. INSTALL BACK PANEL TRIM

7. INSTALL BACK PANEL GARNISH HOLE PLUG 7. INSTALL BACK PANEL GARNISH HOLE PLUG

7. INSTALL BACK PANEL GARNISH HOLE PLUG

8. INSTALL REAR SEAT CUSHION ASSEMBLY 8. INSTALL REAR SEAT CUSHION ASSEMBLY

8. INSTALL REAR SEAT CUSHION ASSEMBLY

(a) Install the 2 rear seat cushion assemblies with the 6 bolts.

Torque:

30 N·m {306 kgf·cm, 22 ft·lbf}

Removal
REMOVAL PROCEDURE 1. REMOVE REAR SEAT CUSHION ASSEMBLY (a) Remove the 6 bolts and 2 rear seat cushion assemblies. 2. REMOVE NO. 4 ROOM PARTITIO ...

Rear Seat Assembly(for Lh Side)
...

Other materials:

Removal
REMOVAL PROCEDURE 1. REMOVE FUEL PUMP ASSEMBLY (for High Pressure) (See page ) 2. REMOVE NO. 2 FUEL PIPE SUB-ASSEMBLY (a) Loosen the 2 union nuts and remove the No. 2 fuel pipe sub-assembly from the fuel delivery pipe RH and fuel delivery pipe sub-assembly LH. Text in Illustration ...

Operation Check
OPERATION CHECK 1. CHECK PANEL & STEERING SWITCH HINT: The radio and display receiver assembly panel switches and steering switches are checked in the following procedure. Illustrations may differ from the actual vehicle screen depending on the device settings and options. ...

TC and CG Terminal Circuit
DESCRIPTION DTC output mode is set by connecting terminals TC and CG of the DLC3. The DTCs are displayed by blinking the SRS warning light. HINT: Make sure that DTCs which relate to the CAN communication system are not output. If any of these DTCs are output, check the CAN communicat ...

© 2011-2026 Copyright www.ttguide.net