Installation
ComponentsCombination Meter
Components
COMPONENTS
ILLUSTRATION
Removal
REMOVAL
PROCEDURE
1. PRECAUTION
NOTICE:
After turning the ignition switch off, waiting time may be required before disconnecting
the cable from the negative (-) battery terminal. Therefore, make sure to read the
disconnecting the cable fro ...
Disassembly
DISASSEMBLY
PROCEDURE
1. REMOVE KNUCKLE GREASE RETAINER CAP (for 2WD)
(a) Using a screwdriver and hammer, remove the knuckle grease retainer cap.
2. REMOVE FRONT AXLE HUB OIL SEAL (for 4WD)
(a) Using a screwdriver and hammer, remove the front axle hub oil seal.
3. REMOVE FRONT WHEEL ADJUST ...
Dtc Check / Clear
DTC CHECK / CLEAR
NOTICE:
When the diagnosis system is changed from normal mode to check mode or vice versa,
all DTCs and freeze frame data recorded in normal mode are cleared. Before changing
modes, always check and make a note of DTCs and freeze frame data.
HINT:
DTCs which are sto ...