Toyota Tacoma (2015-2018) Service Manual: Emission Control System
Installation
INSTALLATION
PROCEDURE
1. INSTALL CHARCOAL CANISTER LEAK DETECTION PUMP SUB-ASSEMBLY
(a) Engage the 2 claws to install a new charcoal canister leak detection
pump sub-assembly to the ...
On-vehicle Inspection
ON-VEHICLE INSPECTION
PROCEDURE
1. INSPECT FUEL CUT OPERATION
(a) Start the engine and warm it up.
(b) Increase the engine speed to at least 3500 rpm.
(c) Use a sound scope to check for fuel inje ...
Other materials:
Replacement
REPLACEMENT
CAUTION / NOTICE / HINT
NOTICE:
Immediately wash off any brake fluid that comes into contact with any painted
surfaces.
HINT:
If any work is done on the brake system or if air in the brake lines is suspected,
bleed the air from the system.
PROCEDURE
1. FILL RESERVOIR WITH BRAK ...
Brake Switch "A" Circuit (P0571)
DESCRIPTION
Detection condition 1:
When the brake pedal is depressed, the stop light switch assembly outputs
a signal to the ECM. When the ECM receives the signal, it cancels control
of vehicle speed by the dynamic radar cruise control system. The fail-safe
function operates to ...
Diagnostic Trouble Code Chart
DIAGNOSTIC TROUBLE CODE CHART
HINT:
If a trouble code is output during the DTC check, inspect the trouble areas listed
for that code. For details of the code, refer to the "See page" below.
Certification ECU (Smart Key ECU Assembly)
DTC Code
Detection Item
...
