Toyota Tacoma (2015-2018) Service Manual: Differential Carrier Oil Seal

Installation

INSTALLATION CAUTION / NOTICE / HINT HINT: The following procedures are for BD22 (w/ Differential Lock). PROCEDURE 1. INSTALL REAR DIFFERENTIAL CARRIER ASSEMBLY (a) Clean the contact surfaces of ...

Removal

REMOVAL PROCEDURE 1. DRAIN DIFFERENTIAL OIL 2. REMOVE PROPELLER WITH CENTER BEARING SHAFT ASSEMBLY (for 2WD) 3. REMOVE PROPELLER WITH CENTER BEARING SHAFT ASSEMBLY (for 4WD) 4. REMOVE REAR ...

Other materials:

Inspection
INSPECTION PROCEDURE 1. INSPECT HEADLIGHT DIMMER SWITCH ASSEMBLY (a) Check the resistance. (1) Measure the resistance according to the value(s) in the table below. Text in Illustration *a Component without harness connected (Headlight Dimme ...

Invalid Data Received from Deceleration Sensor (C1442,C1443)
DESCRIPTION The airbag sensor assembly has a built-in yaw rate and acceleration sensor. The skid control ECU (brake actuator assembly) receives signals from the yaw rate and acceleration sensor (airbag sensor assembly) via the CAN communication system. DTC No. Detection ...

Seat belts
Make sure that all occupants are wearing their seat belts before driving the vehicle. ■ Correct use of the seat belts ● Extend the shoulder belt so that it comes fully over the shoulder, but does not come into contact with the neck or slide off the shoulder. ● Position the ...