Toyota Tacoma (2015-2018) Service Manual: Check Mode Procedure
CHECK MODE PROCEDURE
1. Check Mode (Signal Check): DTC CHECK
(a) Connect the Techstream to the DLC3.
(b) Turn the ignition switch to ON and turn the Techstream on.
(c) Select the Signal Check on the Techstream, and proceed checking with the Techstream.
System Description
SYSTEM DESCRIPTION
1. SRS (SUPPLEMENTAL RESTRAINT SYSTEM) AIRBAG SYSTEM
(a) General Description
(1) The SRS airbag system consists of the following airbag and main components:
Airbag
...
Diagnosis System
DIAGNOSIS SYSTEM
1. CHECK DLC3
(a) The vehicle ECUs use ISO 15765-4 communication protocol. The terminal arrangement
of the DLC3 complies with ISO 15031-3 and matches the ISO 15765-4 format.
...
Other materials:
Hydraulic Test
HYDRAULIC TEST
1. PERFORM HYDRAULIC TEST
(a) Measure the line pressure.
CAUTION:
The line pressure test should always be performed with at least 2 people. One
person should observe the condition of the wheels and wheel chocks while the other
is performing the test.
NOTICE:
Perform ...
Inspection
INSPECTION
PROCEDURE
1. INSPECT CLUTCH DISC ASSEMBLY
NOTICE:
When replacing the clutch disc assembly, make sure to perform an inspection of
the flywheel sub-assembly and clutch cover assembly.
(a) Using a vernier caliper, measure the rivet depth.
Minimum rivet depth:
0.3 mm ...
Rear Power Outlet Socket
Components
COMPONENTS
ILLUSTRATION
ILLUSTRATION
Installation
INSTALLATION
PROCEDURE
1. INSTALL POWER OUTLET SOCKET ASSEMBLY
(a) Install the clamp.
(b) Connect the connector.
(c) Using a torx socket wrench T30, install the 4 screws and the power
outlet socket assemb ...
