Toyota Tacoma (2015-2018) Service Manual: Installation

Toyota Tacoma (2015-2018) Service Manual / Air Conditioning / Air Conditioning Panel(for Manual Air Conditioning System) / Installation

INSTALLATION

PROCEDURE

1. INSTALL TRANSFER POSITION SWITCH (for 4WD)

Click here 2. INSTALL ENGINE SWITCH

2. INSTALL ENGINE SWITCH

Click here 3. INSTALL AIR CONDITIONING CONTROL ASSEMBLY

3. INSTALL AIR CONDITIONING CONTROL ASSEMBLY

(a) Connect the connectors.

(b) Engage the 8 clips to install the air conditioning control assembly.

4. INSTALL RADIO AND DISPLAY RECEIVER ASSEMBLY WITH BRACKET (w/o Navigation System)

Click here 5. INSTALL NAVIGATION RECEIVER ASSEMBLY WITH BRACKET (w/ Navigation System)

5. INSTALL NAVIGATION RECEIVER ASSEMBLY WITH BRACKET (w/ Navigation System)

Click here 6. INSTALL INSTRUMENT PANEL LOWER FINISH PANEL SUB-ASSEMBLY

6. INSTALL INSTRUMENT PANEL LOWER FINISH PANEL SUB-ASSEMBLY

Click here 7. INSTALL INSTRUMENT CLUSTER FINISH PANEL ASSEMBLY

7. INSTALL INSTRUMENT CLUSTER FINISH PANEL ASSEMBLY

Click here 8. INSTALL INSTRUMENT CLUSTER CENTER FINISH PANEL SUB-ASSEMBLY

8. INSTALL INSTRUMENT CLUSTER CENTER FINISH PANEL SUB-ASSEMBLY

Click here 9. INSTALL COWL SIDE TRIM BOARD LH

9. INSTALL COWL SIDE TRIM BOARD LH

Click here 10. INSTALL FRONT DOOR SCUFF PLATE LH (for Access Cab)

10. INSTALL FRONT DOOR SCUFF PLATE LH (for Access Cab)

Click here 11. INSTALL FRONT DOOR SCUFF PLATE LH (for Double Cab)

11. INSTALL FRONT DOOR SCUFF PLATE LH (for Double Cab)

Click here Removal

Inspection

INSPECTION PROCEDURE 1. INSPECT AIR CONDITIONING CONTROL ASSEMBLY (a) Check the blower switch resistance. (1) Measure the resistance according to the value(s) in the table below. T ...

Removal

REMOVAL PROCEDURE 1. REMOVE FRONT DOOR SCUFF PLATE LH (for Double Cab) Click here 2. REMOVE FRONT DOOR SCUFF PLATE LH (for Access Cab) Click here 3. REMOVE COWL SIDE TRIM BOARD LH Click her ...

Other materials:

Installation
INSTALLATION CAUTION / NOTICE / HINT HINT: Perform "Inspection After Repairs" after replacing the fuel injector assembly (See page ). PROCEDURE 1. INSTALL FUEL INJECTOR ASSEMBLY HINT: Perform "Inspection After Repairs" after replacing the fuel injector assembly (See p ...

Disposal
DISPOSAL PROCEDURE 1. DISPOSE OF BRAKE BOOSTER ACCUMULATOR ASSEMBLY (a) Place the brake booster accumulator in a vise and cover it with a cloth. (b) Slowly cut a hole on the brake booster accumulator side in the A portion shown in the illustration on the left. And discharge the gas and liqui ...

ECU Malfunction (B1003)
DESCRIPTION DTC No. DTC Detection Condition Trouble Area B1003 A malfunction in the non-volatile storage of the central gateway ECU (network gateway ECU) is detected. Central gateway ECU (network gateway ECU) PROC ...