TTGuideTacoma manuals & technical reference
Toyota Tacoma (2015-2018) Service Manual / Air Conditioning / Air Conditioning Panel(for Manual Air Conditioning System) / Removal

Toyota Tacoma (2015-2018) Service Manual: Removal

REMOVAL

PROCEDURE

1. REMOVE FRONT DOOR SCUFF PLATE LH (for Double Cab)

Click here 2. REMOVE FRONT DOOR SCUFF PLATE LH (for Access Cab)

2. REMOVE FRONT DOOR SCUFF PLATE LH (for Access Cab)

Click here 3. REMOVE COWL SIDE TRIM BOARD LH

3. REMOVE COWL SIDE TRIM BOARD LH

Click here 4. REMOVE INSTRUMENT CLUSTER CENTER FINISH PANEL SUB-ASSEMBLY

4. REMOVE INSTRUMENT CLUSTER CENTER FINISH PANEL SUB-ASSEMBLY

Click here 5. REMOVE INSTRUMENT CLUSTER FINISH PANEL ASSEMBLY

5. REMOVE INSTRUMENT CLUSTER FINISH PANEL ASSEMBLY

Click here 6. REMOVE INSTRUMENT PANEL LOWER FINISH PANEL SUB-ASSEMBLY

6. REMOVE INSTRUMENT PANEL LOWER FINISH PANEL SUB-ASSEMBLY

Click here 7. REMOVE NAVIGATION RECEIVER ASSEMBLY WITH BRACKET (w/ Navigation System)

7. REMOVE NAVIGATION RECEIVER ASSEMBLY WITH BRACKET (w/ Navigation System)

Click here 8. REMOVE RADIO AND DISPLAY RECEIVER ASSEMBLY WITH BRACKET (w/o Navigation System)

8. REMOVE RADIO AND DISPLAY RECEIVER ASSEMBLY WITH BRACKET (w/o Navigation System)

Click here 9. REMOVE AIR CONDITIONING CONTROL ASSEMBLY

9. REMOVE AIR CONDITIONING CONTROL ASSEMBLY

(a) Disengage the 8 clips.

(b) Disconnect the connectors to remove the air conditioning control assembly.

10. REMOVE ENGINE SWITCH

Click here 11. REMOVE TRANSFER POSITION SWITCH (for 4WD)

11. REMOVE TRANSFER POSITION SWITCH (for 4WD)

Click here Air Conditioning Pressure Sensor

    Related Tacoma materials

    Precaution
    PRECAUTION IGNITION SWITCH EXPRESSIONS (a) The type of ignition switch used on this model differs according to the specifications of the vehicle. The expressions listed in the table below are used in this section. Expression Ignition Switch (Position) Engine Swi ...

    Brake Control Signal Mismatch (C1A69)
    DESCRIPTION The skid control ECU (master cylinder solenoid)*1 or skid control ECU (brake actuator assembly)*2 sends signals to the millimeter wave radar sensor assembly according to the brake control status. If the millimeter wave radar sensor assembly receives a vehicle stability control sys ...

    Disassembly
    DISASSEMBLY PROCEDURE 1. REMOVE INTAKE VALVE (a) Using SST, compress the inner compression spring and remove the valve spring retainer locks. SST: 09202-70020 SST: 09202-00021 09202-01010 09202-01020 (b) Remove the valve s ...