Toyota Tacoma (2015-2018) Service Manual: Diagnosis System
DIAGNOSIS SYSTEM
CHECK DLC3
(a) Check the DLC3.
Click here .gif)
FUNCTION OF WARNING INDICATOR AND MESSAGE
(a) If the lane departure alert system is not functioning properly, the driver is warned by the lane departure alert indicator and multi-information display warning message on the combination meter assembly.
|
Master Warning Indicator |
Warning Message |
Detail |
DTC |
Lane Departure Alert Indicator |
|---|---|---|---|---|
|
Illuminated |
Lane Departure Alert Malfunction Visit Your Dealer |
Lane departure alert system is malfunctioning |
Stored |
Illuminates (yellow) |
|
Not illuminated |
Forward Camera Unavailable |
Forward recognition camera temporarily malfunctioning
|
Not stored |
Illuminates (yellow) |
|
Illuminated |
Forward Camera System Unavailable Clean Windshield |
Forward recognition camera view is unclear |
Not stored |
Illuminates (yellow) |
|
Lane Departure Alert Indicator |
Status |
|---|---|
|
Illuminates (yellow) |
The lane departure alert system is malfunctioning or temporarily disabled |
|
Blinks (yellow) |
Lane departure warning function is operating |
|
Illuminates (green) |
Lane departure alert system is operating |
|
Not illuminated |
Lane departure alert system are not operating |
Utility
UTILITY
NOTICE:
If the forward recognition camera has been replaced due to a malfunction in the
lane departure alert system, be sure to perform Recognition Camera/Target Position
Memory and Opti ...
Terminals Of Ecu
TERMINALS OF ECU
FORWARD RECOGNITION CAMERA
NOTICE:
DTCs may be output when connectors are disconnected during inspection.
Therefore, be sure to clear the DTCs using the Techstream once ...
Other materials:
Power Source Mode does not Change to ON (IG and ACC)
DESCRIPTION
If any of the following operations are performed, the certification ECU (smart
key ECU assembly) receives a signal, and changes the power source mode.
With the electrical key transmitter sub-assembly in the cabin, the engine
switch is pressed.
When the battery of the e ...
Installation
INSTALLATION
PROCEDURE
1. INSTALL PROPELLER SHAFT WITH CENTER BEARING ASSEMBLY
(a) Remove SST from the extension housing.
(b) Install the propeller shaft to the extension housing.
(c) Completely remove any oil or the like and clean the contact surfaces of the
propeller shaft flange and diff ...
Short to +B in Buzzer (C1ABD,C1ABE)
DESCRIPTION
DTC C1ABD is stored when the blind spot monitor sensor RH detects a
+B short in rear cross traffic alert buzzer (blind spot monitor buzzer)
circuit.
DTC C1ABE is stored when the blind spot monitor sensor RH detects a
ground short or open in rear cross traffic aler ...
