Toyota Tacoma (2005–2015) Owners Manual
- Exterior
- Interior
- Instrument panel
- Luggage compartment
- Luggage compartment
- For your information
- Main Owners Manual
- Noise from under vehicle after turning off the engine
- Accessories, spare parts and modification of your Toyota
- Installation of a mobile two-way radio system
- Vehicle data recordings
- Event data recorder
- Scrapping of your Toyota
- Perchlorate Material
- Symbols used throughout this manual
- Before driving
- Key information
- Opening, closing and locking the doors
- Adjustable components (seats, mirrors, steering wheel)
- Rear seats (Access Cab and Double Cab models)
- Opening and closing the windows
- Refueling
- Theft deterrent system
- Safety information
- When driving
- Driving procedures
- Gauges and meters
- Operating the lights and wipers
- Using other driving systems
- Driving information
- Interior and exterior features
- Using the air conditioning system and defogger
- Using the interior lights
- Using the storage features
- Other interior features
- Maintenance and care
- When trouble arises
- When trouble arises
- Vehicle specifications
- For owners
- Reporting safety defects for U.S. owners
- Seat belt instructions for Canadian owners (in French)
- SRS airbag instructions for Canadian owners (in French)
- Camper information
- What to do if...
Exterior
...
Other materials:
Compressor Lock Sensor Circuit (B1422/22)
SYSTEM DESCRIPTION
The ECM sends the engine speed signal to the air conditioning amplifier assembly
via CAN communication.
The air conditioning amplifier assembly reads the difference between compressor
speed and engine speed. When the difference becomes too large, the air conditioning
ampli ...
Installation
INSTALLATION
PROCEDURE
1. INSPECT PROPELLER SHAFT WITH CENTER BEARING ASSEMBLY (with Grease Fitting)
Text in Illustration
*1
Grease Fitting
-
-
*a
View A
*b
Front Side
HINT:
When replacing t ...
Clutch Start Cancel Switch
Inspection
INSPECTION
PROCEDURE
1. INSPECT CLUTCH START CANCEL SWITCH ASSEMBLY
(a) Using an ohmmeter, check that there is resistance between terminals
2 and 4.
Standard:
10 kΩ or higher
If the result is not as specified, replace the clutch start cancel switch.
...
