TTGuideTacoma manuals & technical reference
HomeLatestPopularManual indexSearchContacts
Toyota Tacoma (2015-2018) Service Manual / Vf2cm Transfer / Touch Select 2-4 And High-low System

Toyota Tacoma (2015-2018) Service Manual: Touch Select 2-4 And High-low System

  • Parts Location
  • Precaution
  • How To Proceed With Troubleshooting
  • System Description
  • System Diagram
  • Diagnosis System
  • Dtc Check / Clear
  • Problem Symptoms Table
  • Terminals Of Ecu
  • Data List / Active Test
  • Fail-safe Chart
  • Freeze Frame Data
  • Diagnostic Trouble Code Chart
  • Front Differential Oil Temperature Sensor Circuit Low (P17C7)
  • Front Differential Oil Temperature Sensor Circuit High (P17C8)
  • Four Wheel Drive (4WD) Low Switch Circuit Range / Performance (P2772)
  • Invalid Data Received From Vehicle Dynamics Control Module (U0416)
  • Automatic Disconnecting Differential Motor Control Circuit Open (P17A0)
  • Automatic Disconnecting Differential Motor Limit Switch Circuit (P17A4)
  • Transfer Shift Motor Control Circuit Circuit Open (P17A8)
  • Four Wheel Drive (4WD) Range Signal Circuit Range / Performance (P279E)
  • Transfer Shift Motor Control Circuit Low (P17A9)
  • Transfer Shift Motor Control Circuit High (P17AA)
  • Transfer Shift Motor Limit Switch Circuit (P17AC)
  • Clutch Switch Circuit
  • Lost Communication with ECM / PCM "A" (U0100,U0122)
  • 4WD Control Switch Circuit
  • ECU Power Source Circuit
Installation
INSTALLATION PROCEDURE 1. INSTALL TRANSFER POSITION SWITCH (a) Attach the 2 claws to install the transfer position switch. 2. INSTALL AIR CONDITIONING CONTROL ASSEMBLY (for Automatic Air Condition ...

Parts Location
PARTS LOCATION ILLUSTRATION ILLUSTRATION ...

Related Tacoma materials

Blind Spot Monitor Slave Module Beam Axis Inspection Incomplete (C1ABC)
DESCRIPTION This DTC is stored when a beam axis inspection has not been performed for the blind spot monitor sensor RH. HINT: This DTC is always stored after replacing a blind spot monitor sensor. The purpose of this DTC is to ensure that beam axis inspection is performed. Completing the be ...

Diameter of the Tire is not Uniform (C1337)
DESCRIPTION The skid control ECU (brake actuator assembly) measures the speed of each wheel by receiving signals from the speed sensors. These signals are used for recognizing whether all 4 wheels are operating properly. Therefore, all wheel signals must indicate the same speed. D ...

System Description
SYSTEM DESCRIPTION 1. NAVIGATION SYSTEM OUTLINE (a) Vehicle position tracking methods It is essential that the navigation system correctly tracks the current vehicle position and displays it on the map. There are 2 methods to track the current vehicle position: autonomous (dead reckoning) and ...

TTGuideToyota Tacoma manuals and technical documentation.
В© 2011-2026 www.ttguide.net