Toyota Tacoma (2015-2018) Service Manual: Precaution
PRECAUTION
1. IGNITION SWITCH EXPRESSION
(a) The type of ignition switch used on this model differs depending on the specifications of the vehicle.
The expressions listed in the table below are used in this section.
|
Expression |
Ignition Switch (Position) |
Engine Switch (Condition) |
|---|---|---|
|
Ignition Switch off |
LOCK |
Off (Lock) |
|
Ignition Switch ACC |
ACC |
On (ACC) |
|
Ignition Switch ON |
ON |
On (IG) |
|
Engine Start |
START |
On (Start) |
2. TROUBLESHOOTING PRECAUTION
(a) When there is a malfunction in the contact point of the terminals or installation problems with parts, removal and installation of the suspected problem parts may return the system to the normal condition either completely or temporarily.
(b) In order to determine the malfunctioning area, be sure to check the conditions at the time the malfunction occurred, such as by DTC output and record them before disconnecting each connector or removing and installing parts.
(c) Since the Touch Select 2-4 and High-Low System may be influenced by a malfunction in other systems, be sure to check for DTCs in the other systems.
3. CAN COMMUNICATION SYSTEM PRECAUTION
(a) The CAN communication system is used for data communication between each of the ECUs and sensors. If there is trouble in the CAN communication line, the DTC of the communication line is output.
(b) If the DTC of the CAN communication line is output, repair the malfunction in the communication line and troubleshoot the Touch Select 2-4 and High-Low System.
(c) Since the CAN communication line has its own length and route, it cannot be repaired temporarily with the bypass wire, etc.
4. PRECAUTION FOR WHEN TESTING BRAKES, SPEEDOMETER, ETC.
(a) Make sure that the transfer is in 2WD mode.
Parts Location
PARTS LOCATION
ILLUSTRATION
ILLUSTRATION
...
How To Proceed With Troubleshooting
CAUTION / NOTICE / HINT
HINT:
Use the following procedure listed to troubleshoot the touch select
2-4 and high-low system.
*: Use the Techstream.
PROCEDURE
1.
...
Other materials:
All Door Entry Lock/Unlock Functions do not Operate, but Wireless Functions
Operate
DESCRIPTION
When the wireless operation can be used to lock and unlock the doors, communication
between the electrical key and TPMS receiver assembly and certification ECU (smart
key ECU assembly) is normal. If the entry lock and unlock functions do not operate,
the entry cancel function may ...
Pump Motor Relay (C1253)
DESCRIPTION
The motor relay (semiconductor relay) is built into the master cylinder solenoid
and drives the pump motor based on a signal from the skid control ECU (master cylinder
solenoid).
DTC No.
DTC Detecting Condition
Trouble Areas
C1253
...
How To Proceed With Troubleshooting
CAUTION / NOTICE / HINT
HINT:
Use these procedures to troubleshoot the rear view monitor system.
PROCEDURE
1.
VEHICLE BROUGHT TO WORKSHOP
NEXT
2.
CUSTOMER PROBLEM ANALYSIS
...
