Toyota Tacoma (2015-2018) Service Manual: Roof Drip Side Finish Moulding

Rear Door Black Out Tape

Components COMPONENTS ILLUSTRATION Installation INSTALLATION CAUTION / NOTICE / HINT HINT: Use the same procedure for the RH and LH sides. The procedure described below is for ...

Components

COMPONENTS ILLUSTRATION ILLUSTRATION ...

Other materials:

On-vehicle Inspection
ON-VEHICLE INSPECTION PROCEDURE 1. CHECK FUEL PUMP OPERATION AND INSPECT FOR FUEL LEAK (a) Connect the Techstream to the DLC3. (1) Turn the ignition switch to ON. NOTICE: Do not start the engine. (2) Turn the Techstream on. (3) Enter the following menus: Powertrain / Engine / Active Test / C ...

Reassembly
REASSEMBLY PROCEDURE 1. INSTALL GENERATOR DRIVE END FRAME BEARING (a) Using SST and a press, press in a new generator drive end frame bearing. SST: 09950-60010 09951-00470 SST: 09950-70010 09951-07100 (b) Fit the ta ...

On-vehicle Inspection
ON-VEHICLE INSPECTION PROCEDURE 1. INSPECT INDICATOR LIGHT (a) Inspect the 4HI Indicator Light: (1) Start the engine. (2) Change the 4WD control switch from 2WD to 4H. (3) Check the 4HI indicator light. OK: The 4HI indicator light comes on or the 4HI indicator light comes on after it is b ...