Reassembly
REASSEMBLY
PROCEDURE
1. INSTALL REAR BUMPER SIDE STAY LH
(a) Install the rear bumper side stay LH with the 2 bolts.
Torque:
30 N·m {306 kgf·cm, 22 ft·lbf}
...
Components
COMPONENTS
ILLUSTRATION
ILLUSTRATION
ILLUSTRATION
...
Related Tacoma materials
Lost Communication with Brake System Control Module (U0129/29)
DESCRIPTION
The tire pressure warning ECU and receiver receives signals from the skid control
ECU (brake actuator assembly) via the CAN communication system.
DTC No.
DTC Detection Condition
Trouble Area
U0129/29
Lost communication with ...
Cup holders
Type A (Bench type front seat)
Type B (Separated type front seats
with an automatic transmission)
Type C (Separated type front seats
with a manual transmission)
■Removing the cup holder
Type A (Bench type front seat)
Pull the cup holder up.
Type B (Separated type front s ...
ECU Power Source Circuit
DESCRIPTION
This circuit supplies power to the millimeter wave radar sensor assembly when
the ignition switch is ON.
WIRING DIAGRAM
CAUTION / NOTICE / HINT
NOTICE:
Inspect the fuses for circuits related to this system before performing the following
inspection procedure.
PROCEDURE
...