Toyota Tacoma (2015-2018) Service Manual: Precaution

HINT:

• Any digits beyond the 0.01 mm (1/1000 in.) place for standard, minimum and maximum values should be used as a reference only.
• When both standard and maximum or minimum values are listed for an inspection, use the standard value as a reference only and base any judgments on the maximum and minimum values.

Components

COMPONENTS ILLUSTRATION ILLUSTRATION ...

Disassembly

DISASSEMBLY PROCEDURE 1. REMOVE INTAKE VALVE (a) Using SST, compress the inner compression spring and remove the valve spring retainer locks. SST: 09202-70020 SST: 09202-00021 ...

Other materials:

Removal
REMOVAL PROCEDURE 1. REMOVE FRONT FENDER SEAL LH (a) Remove the 5 clips and front fender seal LH. 2. REMOVE FRONT FENDER SEAL RH HINT: Use the same procedure as for the LH side. 3. REMOVE FRONT EXHAUST PIPE ASSEMBLY (a) Disengag ...

Brake Control Signal Mismatch (C1A69)
DESCRIPTION The skid control ECU (master cylinder solenoid)*1 or skid control ECU (brake actuator assembly)*2 sends signals to the millimeter wave radar sensor assembly according to the brake control status. If the millimeter wave radar sensor assembly receives a vehicle stability control sys ...

Precaution
PRECAUTION 1. IGNITION SWITCH EXPRESSIONS (a) The type of ignition switch used on this model differs according to the specifications of the vehicle. The expressions listed in the table below are used in this section. Expression Ignition Switch (Position) Engine ...