Toyota Tacoma (2015-2018) Service Manual: On-vehicle Inspection
ON-VEHICLE INSPECTION
PROCEDURE
1. INSPECT STEERING PAD (for Vehicle not Involved in Collision)
(a) Perform a diagnostic system check (See page
.gif)
).
(b) With the steering pad installed on the vehicle, perform a visual check. If there are any defects as mentioned below, replace the steering pad with a new one:
Cuts, minute cracks or marked discoloration on the steering pad top surface or in the grooved portion.
2. INSPECT STEERING PAD (for Vehicle Involved in Collision and Airbag has not Deployed)
(a) Perform a diagnostic system check (See page
).
(b) With the steering pad removed from the vehicle, perform a visual check. If there are any defects as mentioned below, replace the steering pad or steering wheel assembly with a new one:
- Cuts, small cracks or marked discoloration on the steering pad top surface or in the grooved portion.
- Cracks or other damage to the connectors.
- Deformation of the steering pad contact plate of the steering pad.
- Deformation of the steering wheel.
- There should be no interference between the steering pad and steering
wheel assembly, and the clearance should be uniform all the way around when
the new steering pad is installed on the steering wheel assembly.
CAUTION:
For removal and installation procedures of the steering pad, be sure to follow the correct procedure.
Components
COMPONENTS
ILLUSTRATION
*1
LOWER NO. 2 STEERING WHEEL COVER
*2
LOWER NO. 3 STEERING WHEEL COVER
*3
STEERING PAD
- ...
Removal
REMOVAL
PROCEDURE
1. PRECAUTION
CAUTION:
Be sure to read Precaution thoroughly before servicing (See page
).
NOTICE:
After turning the ignition switch off, waiting time may be required before ...
Other materials:
Removal
REMOVAL
CAUTION / NOTICE / HINT
CAUTION:
Some of these service operations affect the SRS airbag system. Read the precautionary
notices concerning the SRS airbag system before servicing (See page
).
HINT:
Use the same procedure for the LH side and RH side.
The procedure listed be ...
Freeze Frame Data
FREEZE FRAME DATA
CHECK FREEZE FRAME DATA
HINT:
The ECU records vehicle and driving condition information as freeze frame data
the moment a DTC is stored.
(a) Connect the Techstream to the DLC3.
(b) Turn the ignition switch to ON.
(c) Turn the Techstream on.
(d) Enter the following menus: P ...
Key information
The following keys are provided with the vehicle.
Vehicles without engine immobilizer
system
Master keys
Key number plate
Vehicles with engine immobilizer
system
Master keys
Key number plate
■Key number plate
Keep the plate in a safe place such as your wallet, not in the v ...
