Toyota Tacoma (2015-2018) Service Manual: Lost Communication with ECM / PCM "A" (U0100,U0126,U0129,U0142)
DESCRIPTION
These DTCs are stored if there is a malfunction in the CAN communication system connected to the blind spot monitor sensor.
HINT:
If CAN communication system DTCs are stored, they may also be stored for other systems.
|
DTC Code |
DTC Detection Condition |
Trouble Area |
|---|---|---|
|
U0100 |
Lost communication with ECM |
CAN communication system |
|
U0126 |
Lost communication with steering sensor |
|
|
U0129 |
Lost communication with skid control ECU (brake actuator assembly) |
|
|
U0142 |
Lost communication with main body ECU (driver side junction block assembly) |
CAUTION / NOTICE / HINT
NOTICE:
When checking for DTCs, make sure that the blind spot monitor main switch assembly (warning canceling switch assembly) is on.
PROCEDURE
|
1. |
CHECK DTC |
(a) Clear the DTCs (See page .gif)
).
(b) Check for DTCs (See page ).
|
Result |
Proceed to |
|---|---|
|
DTCs are output |
A |
|
No DTCs are output |
B |
HINT:
- If CAN communication system DTCs are stored, they may also be stored for other systems.
- If the CAN communication system has been inspected and repaired, the DTCs will not be output when rechecking for DTCs.
- If these DTCs are output frequently, duplicate the conditions that cause
the problem symptoms and perform the inspection again, even though the DTC
was not output when rechecking for DTCs (See page
).
| A | .gif) |
GO TO CAN COMMUNICATION SYSTEM |
| B | |
USE SIMULATION METHOD TO CHECK |
Lost Communication with Blind Spot Monitor Slave Module (U0232)
DESCRIPTION
This DTC is stored when the blind spot monitor sensor LH judges that there is
a communication problem with the blind spot monitor sensor RH.
DTC Code
DTC Detectio ...
Short to +B in Buzzer (C1ABD,C1ABE)
DESCRIPTION
DTC C1ABD is stored when the blind spot monitor sensor RH detects a
+B short in rear cross traffic alert buzzer (blind spot monitor buzzer)
circuit.
DTC C1ABE is stored ...
Other materials:
Reassembly
REASSEMBLY
PROCEDURE
1. INSTALL REAR BUMPER SIDE STAY LH
(a) Install the rear bumper side stay LH with the 2 bolts.
Torque:
30 N·m {306 kgf·cm, 22 ft·lbf}
2. INSTALL REAR BUMPER SIDE STAY RH
HINT:
Use the same procedure as for ...
Slip Indicator Light Remains ON
DESCRIPTION
The skid control ECU (brake actuator assembly) is connected to the combination
meter assembly via CAN communication.
The slip indicator light blinks during VSC and/or TRAC operation.
If a malfunction is detected, the slip indicator light comes on to warn the driver
(See page ).
...
Lost Communication with Front Panel LIN (B14B2)
DESCRIPTION
The air conditioning control assembly communicates with the air conditioning
amplifier assembly through the LIN communication system.
If the LIN communication system malfunctions, the air conditioning amplifier
assembly does not operate even if the air conditioning control assembly ...
