Toyota Tacoma (2015-2018) Service Manual: How To Proceed With Troubleshooting

Toyota Tacoma (2015-2018) Service Manual / Lighting / Lighting System / How To Proceed With Troubleshooting

CAUTION / NOTICE / HINT

HINT:

Use these procedures to troubleshoot the lighting system.
*: Use the Techstream.

PROCEDURE

1.	VEHICLE BROUGHT TO WORKSHOP

2.	INSPECT BATTERY VOLTAGE

Standard voltage:

11 to 14 V

If the voltage is below 11 V, recharge or replace the battery before proceeding.

3.	CHECK COMMUNICATION FUNCTION OF CAN COMMUNICATION SYSTEM*

(a) Use the Techstream to check if the CAN communication system is functioning normally.

Result	Proceed to
CAN DTC is not output	A
CAN DTC is output	B

GO TO CAN COMMUNICATION SYSTEM

4.	CHECK FOR DTC*

(a) Clear the DTC.

Click here (b) Recheck for DTC.

(b) Recheck for DTC.

Click here

Result	Proceed to
DTC is not output	A
DTC is output	B

GO TO DIAGNOSTIC TROUBLE CODE CHART

5.	PROBLEM SYMPTOMS TABLE

Result	Proceed to
Fault is not listed in problem symptoms table	A
Fault is listed in problem symptoms table	B

GO TO STEP 7

6.	OVERALL ANALYSIS AND TROUBLESHOOTING*

(a) Operation Check.

Click here

(b) Terminals of ECU.

Click here

7.	ADJUST, REPAIR OR REPLACE

8.	CONFIRMATION TEST

END

Customize Parameters

CUSTOMIZE PARAMETERS 1. CUSTOMIZING FUNCTION WITH TECHSTREAM NOTICE: When the customer requests a change in a function, first make sure that the function can be customized. Be sure ...

OPERATION CHECK 1. INSPECT INTERIOR LIGHT CONTROL OPERATION NOTICE: Perform this inspection with the customize parameters at the default settings. The interior light control illuminates the lights ...

Other materials:

Dtc Check / Clear
DTC CHECK / CLEAR 1. CHECK DTC (a) Check the DTCs. (1) Turn the ignition switch off. (2) Connect the Techstream to the DLC3. (3) Turn the ignition switch to ON. (4) Turn the Techstream on. (5) Read the DTCs following the prompts on the Techstream screen. Enter the following menus: Powertrai ...

Removal
REMOVAL PROCEDURE 1. REMOVE FRONT WHEEL 2. INSPECT FRONT SUSPENSION LOWER ARM (a) Install the hub nuts onto the disc. (b) Using a dial indicator, check the lower ball joint for excessive play when you push the hub nuts up and down with a force of 294 N (30 kgf, 66 lbf). Maximum: 0.5 mm ( ...

Components
COMPONENTS ILLUSTRATION *A w/o Woofer *B w/ Woofer *1 LUGGAGE COMPARTMENT SIDE TRAY LH *2 LUGGAGE COMPARTMENT SIDE TRAY RH ILLUSTRATION *1 COWL SIDE TRIM BOARD LH ...