Toyota Tacoma manuals

Toyota Tacoma (2015-2018) Service Manual: Fail-safe Chart

FAIL-SAFE CHART

FAIL-SAFE FUNCTION

(a) When a malfunction occurs in the lane departure alert system, a message will be displayed on the multi-information display in the combination meter assembly and the lane departure alert system will be disabled depending on the malfunction.

Warning Message

Cause

Fail-safe Operation

Conditions to Return to Normal Condition

Lane Departure Alert Function

Vehicle Sway Warning

Lane Departure Alert Malfunction Visit Your Dealer

Lane departure alert system is malfunctioning

X

X

After system returns to normal, ignition switch is turned off and then to ON

Front Camera Unavailable

  • Abnormal forward recognition camera voltage
  • Forward recognition camera temperature outside of operational range
  • Other forward recognition camera malfunction

X

X

  • Forward recognition camera temperature returns to normal
  • Forward recognition camera voltage returns to normal
  • Forward recognition camera returns to normal

Front Camera Vision Blocked Clean and Demist Windshield

Forward recognition camera view is unclear

X

X

Forward recognition camera or area of windshield glass in front of forward recognition camera is cleaned

X: Control is suspended

Diagnostic Trouble Code Chart
DIAGNOSTIC TROUBLE CODE CHART LANE DEPARTURE ALERT SYSTEM DTC No. Detection Item Link C1A47 Steering Angle Sensor ...

Steering Angle Sensor (C1A47)
DESCRIPTION The forward recognition camera receives steering angle information from the spiral cable with sensor sub-assembly. If the forward recognition camera detects a spiral cable with sensor ...

Other materials:

Inspection
INSPECTION PROCEDURE 1. INSPECT MAGNET STARTER SWITCH ASSEMBLY (a) Inspect the pull-in coil. (1) Measure the resistance according to the value(s) in the table below. Text in Illustration *a Terminal 50 *b ...

Open or Short in Rear Speed Sensor RH Circuit (C1407,C1408)
DESCRIPTION Refer to DTCs C1403 and C1404 (See page ). DTC No. Detection Item DTC Detection Condition Trouble Area C1407 Open or Short in Rear Speed Sensor RH Circuit Either of the following is detected: ...

Stop Light Relay Circuit (C1A4B)
DESCRIPTION The skid control ECU (master cylinder solenoid)*1 or skid control ECU (brake actuator assembly)*2 sends a stop light operation request signal to the stop light relay (stop light switch assembly). If the skid control ECU (master cylinder solenoid)*1 or skid control ECU (brake actua ...

В© 2011-2026 Copyright www.ttguide.net