Installation
INSTALLATION
CAUTION / NOTICE / HINT
HINT:
The following procedures are for BD22 (w/ Differential Lock).
PROCEDURE
1. INSTALL REAR DIFFERENTIAL CARRIER ASSEMBLY
(a) Clean the contact surfaces of ...
Removal
REMOVAL
PROCEDURE
1. DRAIN DIFFERENTIAL OIL
2. REMOVE PROPELLER WITH CENTER BEARING SHAFT ASSEMBLY (for 2WD)
3. REMOVE PROPELLER WITH CENTER BEARING SHAFT ASSEMBLY (for 4WD)
4. REMOVE REAR ...
Related Tacoma materials
Removal
REMOVAL
PROCEDURE
1. DRAIN TRANSFER OIL
2. REMOVE FRONT PROPELLER SHAFT ASSEMBLY
3. REMOVE PROPELLER WITH CENTER BEARING SHAFT ASSEMBLY
4. SUPPORT TRANSMISSION ASSEMBLY
5. REMOVE NO. 3 FRAME CROSSMEMBER SUB-ASSEMBLY
6. REMOVE REAR NO. 1 ENGINE MOUNTING INSULATOR
7. SUPPO ...
Vehicle Speed Sensor "A" No Signal (P050031)
DESCRIPTION
Vehicles, which are equipped with ABS (Anti-lock Brake System), detect the vehicle
speed using the skid control ECU (brake actuator assembly) and speed sensors. Each
speed sensor monitors the wheel rotation speed and sends a signal to the skid control
ECU. The skid control ECU con ...
Diagnosis System
DIAGNOSIS SYSTEM
1. DESCRIPTION
(a) The transponder key ECU assembly controls the engine immobiliser system.
The engine immobiliser system data and Diagnostic Trouble Codes (DTCs) can be read
through the vehicle Data Link Connector 3 (DLC3).
2. CHECK DLC3
(a) Check the DLC3 (See page ).
3. ...