Toyota Tacoma (2015-2018) Service Manual: Diagnostic Trouble Code Chart
DIAGNOSTIC TROUBLE CODE CHART
HINT:
If a trouble code is stored during the DTC check, inspect the trouble areas listed for that code. For details of the code, refer to "See page" below.
Transponder Key ECU Assembly|
DTC Code |
Detection Item |
See page |
|---|---|---|
|
B2780 |
Push Switch / Key Unlock Warning Switch Malfunction |
|
|
B2784 |
Antenna Coil Open / Short |
|
|
B2793 |
Transponder Chip Malfunction |
|
|
B2794 |
Unmatched Encryption Code |
|
|
B2797 |
Communication Malfunction No. 1 |
|
|
B2798 |
Communication Malfunction No. 2 |
|
.gif)
HINT:
The DTCs for the engine immobiliser system are specified below. If other codes are output, check the DTC chart for the SFI system.
ECM|
DTC Code |
Detection Item |
See page |
|---|---|---|
|
B2799*1 |
Engine Immobiliser System Malfunction |
|
|
B279986*2 |
Engine Immobiliser System Signal (Some Circuit Quantity, Reported via Serial Data) Invalid |
|
|
B279A*1 |
Theft Deterrent System Communication Line High Fixation |
|
|
B279A12*2 |
Engine Immobiliser System Circuit Short to Battery |
|
|
B279C*1 |
Theft Deterrent System Presence Detection |
|
|
B279C95*2 |
Engine Immobiliser System Incorrect Assembly |
|
- *1: for 2TR-FE
- *2: for 2GR-FKS
Data List / Active Test
DATA LIST / ACTIVE TEST
1. DATA LIST
HINT:
Using the Techstream to read the Data List allows the values or states of switches,
sensors, actuators and other items to be read without removing any p ...
Theft Deterrent System Communication Line High Fixation (B279A,B279A12)
DESCRIPTION
If the communication line (EFIO-IMI) to the transponder key ECU assembly is stuck
high (e.g. shorted to +B), the ECM stores this DTC.
DTC No.
DTC Detection Condit ...
Other materials:
Reassembly
REASSEMBLY
CAUTION / NOTICE / HINT
HINT:
Use the same procedures for both the LH and RH sides.
The procedure described below is for the LH side.
PROCEDURE
1. INSTALL SIDE TURN SIGNAL LIGHT ASSEMBLY (w/ Side Turn Signal Light)
2. INSTALL OUTER MIRROR COVER (w/o Side Turn Si ...
Cursor or Map Rotates when Vehicle Stopped
PROCEDURE
1.
CHECK CONDITION
(a) Check with the customer if the vehicle has been turned by a turntable.
OK:
Vehicle has not been turned by a turntable.
HINT:
If the vehicle is turned on a turntable with the ignition switch ON,
the system ...
Lost Communication with Alternator Missing Message (P161A87)
DESCRIPTION
The ECM communicates with the generator assembly via LIN communication. If a
LIN communication error is detected, the ECM stores this DTC.
DTC No.
DTC Detection Condition
Trouble Area
P161A87
Generator assembly or ECM commu ...
