Toyota Tacoma (2015-2018) Service Manual: Brake Switch "A" Circuit Open (P057113)
DESCRIPTION
When the brakes are applied by the dynamic radar cruise control system, the skid control ECU (master cylinder solenoid)*1 or skid control ECU (brake actuator assembly)*2 operates the stop light switch assembly (stop light relay) to illuminate the stop lights.
If the ECM receives a stop light switch control relay malfunction signal from the skid control ECU (brake actuator assembly), DTC P057113 is stored.
|
DTC No. |
Detection Item |
DTC Detection Condition |
Trouble Area |
MIL |
|---|---|---|---|---|
|
P057113 |
Brake Switch "A" Circuit Open |
While the vehicle speed is 36 km/h (22 mph) or more and the dynamic radar cruise control system is operating, the ECM detects the stop light switch control relay malfunction signal from the skid control ECU (master cylinder solenoid)*1 or skid control ECU (brake actuator assembly)*2 for approximately 0.5 seconds or more. |
Pre-collision system |
Does not come on |
- *1: for Hydraulic Brake Booster
- *2: for Vacuum Brake Booster
CAUTION / NOTICE / HINT
HINT:
When DTC P057113 is stored by the dynamic radar cruise control system, DTC C1A4B is stored by the pre-collision system. Therefore, if DTC P057113 is stored, inspect the pre-collision system first.
PROCEDURE
|
1. |
GO TO PRE-COLLISION SYSTEM |
Click here .gif)
| NEXT | .gif) |
END |
Radar Cruise Control Presence Determination Malfunction (Engine / HV) (C1A52)
DESCRIPTION
DTC C1A52 is stored when the ECM cannot recognize the millimeter wave radar sensor
assembly.
DTC No.
Detection Item
DTC Detection Condition
...
Front Radar Sensor (C1A10)
DESCRIPTION
C1A10 is output when there is an internal malfunction in the millimeter wave
radar sensor assembly.
DTC No.
Detection Item
DTC Detection Condition
...
Other materials:
Sound Quality is Bad Only when CD is Played (Volume is Too Low)
PROCEDURE
1.
REPLACE CD AND RECHECK
(a) Replace the CD with a known good one and check that the malfunction disappears.
OK:
Malfunction disappears.
OK
END
NG
REPLACE RADIO AND DISPLAY RECEIVER ASSEMBLY
...
Disassembly
DISASSEMBLY
CAUTION / NOTICE / HINT
HINT:
The procedure described below is for the LH side. Use the same procedure for
both the LH and RH sides, unless otherwise specified.
PROCEDURE
1. REMOVE REAR SEATBACK COVER
(a) Remove the 2 screws.
...
Brake Fluid(for Hydraulic Brake Booster)
On-vehicle Inspection
ON-VEHICLE INSPECTION
PROCEDURE
1. INSPECT FLUID LEVEL IN RESERVOIR
(a) Turn the ignition switch to OFF, and depress the brake pedal more
than 40 times (until the pedal reaction feels light and pedal stroke becomes
longer), and adjust the fluid level to ...
