Toyota Tacoma manuals

Toyota Tacoma (2015-2018) Service Manual: Diagnostic Trouble Code Chart

DIAGNOSTIC TROUBLE CODE CHART

Forward Recognition Camera System

DTC No.

Detection Item

Link

C1A0A

Front Radar Sensor Region Code Mismatch

C1A47

Steering Angle Sensor

C1AA0

Front Camera Module Circuit

C1AA1

FCM Destination Information Unmatched

C1AA2

Vehicle Speed Tolerance Malfunction

C1AA3

Vehicle Speed Sensor Circuit

C1AA4

Yaw Rate Sensor Circuit

C1AA5

Yaw Rate Sensor Power Supply Voltage Circuit

C1AA7

Skid Control Buzzer Circuit

C1AA8

Front Camera Module Incorrect Axial Gap

C1AA9

Front Camera Module Beam Axis Not Adjusted

C1AAA

FCM Destination Information Uninitialized

C1AAE

Heater Circuit

U0100

Lost Communication with ECM / PCM "A"

U0101

Lost Communication with TCM

U0123

Lost Communication with Yaw Rate Sensor Module

U0126

Lost Communication with Steering Angle Sensor Module

U0129

Lost Communication with Brake System Control Module

U0142

Lost Communication with Body Control Module "B"

U0155

Lost Communication with Combination Meter

U0235

Lost Communication with Cruise Control Front Distance Range Sensor

Data List / Active Test
DATA LIST / ACTIVE TEST DATA LIST HINT: Using the Techstream to read the Data List allows the values or states of switches, sensors, actuators and other items to be read without removing any part ...

Lost Communication with ECM / PCM "A" (U0100,U0101,U0123,U0126,U0129,U0142,U0155)
DESCRIPTION When a malfunction is detected between various ECUs and sensors, these DTCs are stored. DTC No. Detection Item DTC Detection Condition Troub ...

Other materials:

Installation
INSTALLATION PROCEDURE 1. INSTALL PARK/NEUTRAL POSITION SWITCH HINT: Make sure that the manual valve lever shaft has not been rotated prior to installing the park/neutral position switch as the detent spring may become detached from the manual valve lever shaft. (a) Clean the bolt and bolt ...

Pressure Control Solenoid "G" Actuator Stuck Off (P28077F)
SYSTEM DESCRIPTION The ECM uses the vehicle speed signal and signals from the transmission revolution sensors (NT, SP2) to detect the actual gear (1st, 2nd, 3rd, 4th, 5th or 6th gear). The ECM compares the actual gear with the shift schedule in the ECM memory to detect mechanical problems of t ...

Components
COMPONENTS ILLUSTRATION *A w/ Front Spoiler - - *1 RADIATOR GRILLE *2 FRONT NO. 1 WHEEL OPENING EXTENSION PAD ILLUSTRATION *A w/o Over Fender - - ...

В© 2011-2026 Copyright www.ttguide.net