Toyota Tacoma manuals

Toyota Tacoma (2015-2018) Service Manual: A-TRAC Indicator Light does not Come ON

DESCRIPTION

The A-TRAC does not operate even if the A-TRAC switch is pressed under the following conditions:

  • The TRAC or VSC system is faulty.
  • The temperature inside the hydraulic brake booster increases and the A-TRAC operation is suspended.

WIRING DIAGRAM

Refer to A-TRAC Indicator Light Remains ON (See page CAUTION / NOTICE / HINT ).

CAUTION / NOTICE / HINT

NOTICE:

  • When replacing the skid control ECU (master cylinder solenoid), perform calibration (See page ). Inspect the fuses for circuits related to this system before performing ).
  • Inspect the fuses for circuits related to this system before performing the following inspection procedure.

PROCEDURE

1.

CHECK CAN COMMUNICATION SYSTEM

NG

GO TO CAN COMMUNICATION SYSTEM (HOW TO PROCEED WITH TROUBLESHOOTING)

OK

2.

CHECK HARNESS AND CONNECTOR (ATRC TERMINAL)

NG

GO TO STEP 4

OK

3.

READ VALUE USING TECHSTREAM (A-TRC(TRAC) SWITCH)

OK

GO TO METER / GAUGE SYSTEM (HOW TO PROCEED WITH TROUBLESHOOTING)

NG

REPLACE MASTER CYLINDER SOLENOID

4.

INSPECT A-TRAC SWITCH

NG

REPLACE A-TRAC SWITCH

OK

5.

INSPECT ROOF CONSOLE BOX ASSEMBLY

A

REPAIR OR REPLACE HARNESS OR CONNECTOR (MASTER CYLINDER SOLENOID - ROOF CONSOLE BOX ASSEMBLY)

B

REPLACE ROOF CONSOLE BOX ASSEMBLY

C

REPLACE ROOF CONSOLE BOX ASSEMBLY

Slip Indicator Light does not Come ON
DESCRIPTION Refer to Slip Indicator Light Remains ON (See page ). WIRING DIAGRAM Refer to Slip Indicator Light Remains ON (See page ). CAUTION / NOTICE / HINT NOTICE: When replacing ...

A-TRAC Indicator Light Remains ON
DESCRIPTION This is the A-TRAC main switch circuit. When the A-TRAC switch is turned on with the transfer in L4, the A-TRAC function is available and the A-TRAC indicator light illuminates. WIRI ...

Other materials:

General Information
GENERAL INFORMATION A large number of ECU controlled systems are used in the TOYOTA TACOMA. In general, ECU controlled systems are considered to be very intricate, requiring a high level of technical knowledge to troubleshoot. However, most problem checking procedures only involv ...

Speaker Output Short (B15C3)
DESCRIPTION This DTC is stored when a malfunction occurs in the speakers. DTC No. DTC Detection Condition Trouble Area B15C3 A short is detected in the speaker output circuit. Harness or connector Speaker ...

Lost Communication with ECM / PCM (U0100,U0140,U0142,U0155,U1117)
DESCRIPTION These DTCs are stored when there is a CAN communication malfunction between the certification ECU (smart key ECU assembly), ECM, main body ECU (multiplex network body ECU) or combination meter assembly, and data from the option connector (bus buffer ECU) cannot be received. HINT: ...

В© 2011-2026 Copyright www.ttguide.net