INSTALLATION
PROCEDURE
1. INSTALL REAR ENGINE OIL SEAL
(a) Apply MP grease to the lip of a new rear engine oil seal.
NOTICE:
Keep the lip free of foreign matter.
(b) Using SST, tap in ...
System Diagram
SYSTEM DIAGRAM
Circuit Description
Component
Outline
Steering Lock ECU (Steering Lock Actuator or UPR Bracket Assembly)
The steering is locked and unlocked by communicating with the
certification ECU (smart key ECU assembly) via L ...
Washer Nozzle
Components
COMPONENTS
ILLUSTRATION
On-vehicle Inspection
ON-VEHICLE INSPECTION
PROCEDURE
1. INSPECT WASHER NOZZLE SUB-ASSEMBLY
(a) Operate the washer nozzle sub-assembly and check the position that the washer
fluid hits the windshield.
Standard:
Washer fluid hits the windshield gla ...
Inspection
INSPECTION
PROCEDURE
1. INSPECT AUTO HIGH BEAM SWITCH
*a
Component without harness connected
(Auto High Beam Switch)
(a) Check the resistance.
(1) Measure the resistance according to the value(s) in the table below.
Standard Resistance:
Tester C ...
Installation
Exhaust Manifold