TTGuideTacoma manuals & technical reference
Toyota Tacoma (2015-2018) Service Manual / Audio / Video / Instrument Panel Speaker / Installation

Toyota Tacoma (2015-2018) Service Manual: Installation

INSTALLATION

PROCEDURE

1. INSTALL FRONT NO. 2 SPEAKER ASSEMBLY RH

(a) Connect the connector.

(b) Install the front No. 2 speaker assembly RH with the 2 bolts.

Torque:

8.4 N·m {86 kgf·cm, 74 in·lbf}

NOTICE:

  • Do not touch the cone part of the front No. 2 speaker assembly RH.
  • When installing the front No. 2 speaker assembly RH to the instrument panel, be careful so that the wires do not get caught between the parts.

2. INSTALL FRONT NO. 2 SPEAKER ASSEMBLY LH

(a) Connect the connector.

(b) Install the front No. 2 speaker assembly LH with the 2 bolts.

Torque:

8.4 N·m {86 kgf·cm, 74 in·lbf}

NOTICE:

  • Do not touch the cone part of the front No. 2 speaker assembly LH.
  • When installing the front No. 2 speaker assembly LH to the instrument panel, be careful so that the wires do not get caught between the parts.

3. INSTALL NO. 2 INSTRUMENT PANEL SPEAKER PANEL SUB-ASSEMBLY

(See page 4. INSTALL NO. 1 INSTRUMENT PANEL SPEAKER PANEL SUB-ASSEMBLY 4. INSTALL NO. 1 INSTRUMENT PANEL SPEAKER PANEL SUB-ASSEMBLY )

4. INSTALL NO. 1 INSTRUMENT PANEL SPEAKER PANEL SUB-ASSEMBLY

(See page 5. INSTALL FRONT PILLAR GARNISH RH 5. INSTALL FRONT PILLAR GARNISH RH )

5. INSTALL FRONT PILLAR GARNISH RH

(See page 6. INSTALL ASSIST GRIP SUB-ASSEMBLY 6. INSTALL ASSIST GRIP SUB-ASSEMBLY )

6. INSTALL ASSIST GRIP SUB-ASSEMBLY

(See page 7. INSTALL FRONT PILLAR GARNISH LH 7. INSTALL FRONT PILLAR GARNISH LH )

7. INSTALL FRONT PILLAR GARNISH LH

(See page Microphone Amplifier Microphone Amplifier )

    Related Tacoma materials

    Crawl Switch
    Components COMPONENTS ILLUSTRATION Inspection INSPECTION PROCEDURE 1. INSPECT CRAWL CONTROL SWITCH (DRIVE MONITOR SWITCH) (a) Check the resistance. (1) Measure the resistance according to the value(s) in the table below. Text in Illustration *1 Crawl Control Sw ...

    Terminals Of Ecu
    TERMINALS OF ECU 1. COMBINATION METER ASSEMBLY (a) Measure the voltage, resistance and check for pulses according to the value(s) in the table below. Terminal No. (Symbol) Wiring Color Terminal Description Condition Specified Condition ...

    Dtc Check / Clear
    DTC CHECK / CLEAR NOTICE: When the diagnosis system is changed from normal mode to check mode or vice versa, all DTCs and freeze frame data recorded in normal mode are cleared. Before changing modes, always check and make a note of DTCs and freeze frame data. HINT: DTCs which are sto ...