REMOVAL
PROCEDURE
1. REMOVE INSTRUMENT PANEL SUB-ASSEMBLY
(See page )
2. REMOVE NO. 3 HEATER TO REGISTER DUCT
3. REMOVE INSTRUMENT PANEL WIRE ASSEMBLY
(a) Using a screwdriver with its tip wrapped in protective tape, release the 3 airbag connector locks. Text in Illustration
|
|
(b) Disconnect the 3 airbag connectors.
NOTICE:
When handling the airbag connector, take care not to damage the airbag wire harness.
(c) Disengage the 2 clamps to remove the instrument panel wire assembly.
4. REMOVE INSTRUMENT PANEL PASSENGER AIRBAG ASSEMBLY WITHOUT DOOR
(a) Remove the 2 screws. |
|
(b) Disengage the 3 hooks (A). Text in Illustration
|
|
(c) Disengage the 3 hooks (B) to remove the instrument panel passenger airbag assembly without door from the instrument panel.
Diagnostic Trouble Code Chart
DIAGNOSTIC TROUBLE CODE CHART
Steering Lock System
DTC Code
Detection Item
See page
B2781
Open / Short in Steering Lock ECU
B2782
Power Source Control ECU Malfunction
...
Removal
REMOVAL
PROCEDURE
1. REMOVE SLIDING ROOF SIDE GARNISH LH
(a) Fully open the sunshade trim sub-assembly.
(b) Remove the sliding roof side garnish LH.
2. REMOVE SLIDING ROOF SIDE GARNISH RH
HINT:
Use the same procedure as for the LH side.
3. ...
Disassembly
DISASSEMBLY
PROCEDURE
1. REMOVE SHIFT LOCK RELEASE BUTTON COVER
(a) Using a screwdriver with its tip wrapped in protective tape, detach the 2
claws to remove the shift lock release button cover from the console upper panel
sub-assembly.
Text in Illustration
*a
Protect ...