Toyota Tacoma (2015-2018) Service Manual: Diagnostic Trouble Code Chart

Data List / Active Test

DATA LIST / ACTIVE TEST 1. READ DATA LIST HINT: Using the Techstream to read the Data List allows the values or states of switches, sensors, actuators and other items to be read without removing ...

Open / Short in Steering Lock ECU (B2781)

DESCRIPTION The steering lock ECU and steering lock motor are built into the steering lock actuator assembly. The steering lock ECU (steering lock actuator or UPR bracket assembly) detects wheth ...

Other materials:

On-vehicle Inspection
ON-VEHICLE INSPECTION PROCEDURE 1. INSPECT FRONT AXLE HUB BEARING (a) Remove the front wheel. (b) for 4WD: (1) Remove the front axle hub grease cap (See page ). (c) Remove the front disc brake caliper (See page ). (d) Remove the front disc. (e) Inspect the axle hub backlash. (1) Usi ...

Power Source Mode does not Change to ON (IG)
DESCRIPTION If the engine switch is pressed with the electrical key transmitter sub-assembly in the cabin, the certification ECU (smart key ECU assembly) receives a signal and changes the power source mode. HINT: When the cable is disconnected and reconnected to the negative (-) battery termi ...

Dtc Check / Clear
DTC CHECK / CLEAR 1. CHECK DTC (a) Connect the Techstream to the DLC3. (b) Turn the ignition switch to ON. (c) Turn the Techstream on. (d) Enter the following menus: Powertrain / Engine / Trouble Codes. (e) Check for DTCs, and then write them down. (f) Check the details of the DTCs (See page ...