DISASSEMBLY
PROCEDURE
1. REMOVE SHIFT LOCK RELEASE BUTTON COVER
(a) Using a screwdriver with its tip wrapped in protective tape, detach the 2 claws to remove the shift lock release button cover from the console upper panel sub-assembly.
Text in Illustration
*a |
Protective Tape |
Remove in this Direction |
2. REMOVE SHIFT POSITION INDICATOR
(a) Remove the 4 screws and shift position indicator from the console upper panel sub-assembly. |
|
3. REMOVE INDICATOR LIGHT WIRE SUB-ASSEMBLY
(a) Detach the clamp to separate the indicator light wire sub-assembly from the shift position indicator. |
|
(b) Disconnect the connector to remove the indicator light wire sub-assembly from the shift position indicator.
Reverse Signal Circuit
DESCRIPTION
The radio and display receiver assembly*1 or navigation receiver assembly*2 receives
a reverse signal from the park/neutral position switch*3 or the back-up light switch
assembly*4.
*1: w/o Navigation System
*2: w/ Navigation System
*3: for Automatic Transmission
...
Torque Converter Clutch Pressure Control Solenoid Control Circuit Open (P275613)
DESCRIPTION
Refer to the system description for DTC P27567F (See page
).
DTC No.
DTC Detection Condition
Trouble Area
SAE
P275613
Open or short is detected in shift solenoid valve SLU circuit for 1 second
or more while d ...
Disassembly
DISASSEMBLY
CAUTION / NOTICE / HINT
HINT:
Use the same procedures for both the LH and RH sides.
The procedure described below is for the LH side.
PROCEDURE
1. REMOVE OUTER MIRROR
(a) Push the lower part of the mirror surface and tilt it.
Text in Illustration
...