ON-VEHICLE INSPECTION
PROCEDURE
1. INSPECT INSTRUMENT PANEL PASSENGER AIRBAG ASSEMBLY WITHOUT DOOR (for Vehicle not Involved in Collision)
(a) Perform a diagnostic system check (See page ). |
|
(b) With the instrument panel passenger airbag assembly without door installed on the vehicle, perform a visual check. If there are any defects as mentioned below, replace the instrument panel with a new one:
Cuts, minute cracks or marked discoloration on the instrument panel around the instrument panel passenger airbag assembly without door.
2. INSPECT INSTRUMENT PANEL PASSENGER AIRBAG ASSEMBLY WITHOUT DOOR (for Vehicle Involved in Collision and Airbag has not Deployed)
(a) Perform a diagnostic system check (See page ). |
|
(b) With the instrument panel passenger airbag assembly without door removed from the vehicle, perform a visual check. If there are any defects as mentioned below, replace the instrument panel passenger airbag assembly without door, instrument panel or instrument panel reinforcement with a new one:
CAUTION:
For removal and installation procedures of the instrument panel passenger airbag assembly without door, be sure to follow the correct procedure.
Cruise Control Input Processor (P160700)
DESCRIPTION
When the ECM determines that there is a malfunction, the ECM illuminates the
MIL and stores a DTC.
HINT:
When these DTCs are stored, the ECM cuts the current supplied to the throttle
motor and the throttle valve returns to the predetermined opening amount by the
return spring.
...
Voice Recognition Microphone Disconnected (B1579)
DESCRIPTION
The radio and display receiver assembly and telephone microphone assembly are
connected to each other using the microphone connection detection signal lines.
This DTC is stored when a microphone connection detection signal line is disconnected.
DTC Code
DTC Det ...
Power Source Circuit
DESCRIPTION
This circuit provides power to operate the blind spot monitor sensor.
WIRING DIAGRAM
CAUTION / NOTICE / HINT
NOTICE:
Inspect the fuses for circuits related to this system before performing the following
inspection procedure.
PROCEDURE
1.
CHECK HARNESS AN ...