Toyota Tacoma (2015-2018) Service Manual: Lost Communication with ECM (U0100,U0142,U0155)
DESCRIPTION
|
DTC No. |
DTC Detecting Condition |
Trouble Area |
|---|---|---|
|
U0100 |
No communication with ECM |
|
|
U0142 |
No communication with main body ECU |
|
|
U0155 |
No communication with combination meter |
|
PROCEDURE
|
1. |
GO TO CAN COMMUNICATION SYSTEM |
HINT:
Refer to CAN Communication System (See page .gif)
).
| NEXT | .gif) |
END |
Air Inlet Damper Position Sensor Circuit (B1432/32)
DESCRIPTION
This sensor detects the position of the air inlet damper and sends the appropriate
signals to the air conditioning amplifier assembly. The position sensor is built
into the No. 1 air ...
Air Outlet Damper Control Servo Motor Circuit (B1443/43)
DESCRIPTION
This No. 1 air conditioning radiator damper servo sub-assembly (for mode switching)
is controlled by the air conditioning amplifier assembly and moves the mode damper
to the desired p ...
Other materials:
Engine Immobiliser System Circuit Short to Battery (B279A12)
DESCRIPTION
When the communication line (IMI - EFIO) between the ECM and certification ECU
(smart key ECU assembly) is stuck high, the ECM stores this DTC.
DTC Code
DTC Detection Condition
Trouble Area
DTC Output Confirmation Operation
...
Invalid Data Received from Deceleration Sensor (C1442,C1443)
DESCRIPTION
The airbag sensor assembly has a built-in yaw rate and acceleration sensor.
The skid control ECU (brake actuator assembly) receives signals from the yaw
rate and acceleration sensor (airbag sensor assembly) via the CAN communication
system.
DTC No.
Detection ...
Initialization
INITIALIZATION
1. ZERO POINT CALIBRATION
NOTICE:
Make sure that the front passenger seat is not occupied before performing the
operation.
HINT:
Perform the zero point calibration and sensitivity check if any of the following
conditions apply.
The occupant detection ECU is replaced. ...
